Running good now
To clear up some confusion the codes I posted were from the CCU. I removed all the added grounds way on back. Today I bought a reman ECM and so far it is running better than it ever has sence I bought it,I just hope it keeps on. Thanks for the input.
New problem
:mad Well now my gages work but the car will not run. It will start up and go dead. The vats has already been bypassed. I was able to pull some cades out last night before it started interupting the snapon scan tool. Codes are 31-33-35-37-54. If I turn the ignition on and leave it...
Found the problem
:L Back in the early spring I was trying to find a miss fire once the engine got warmed up,so I had bought a new capacitor with a new wire harness that goes from the ignition module. Well it did not plug in correctly,the black ground wire did not make good contact with the...
I have a Snapon scan tool there are no codes. I have checked all the grounds that i could find, I've even added a few direct to the computers with no change. I will hook up my scanner and watch to see if it starts at closed loop. Temp does not seem to mater. I have been working with this sense...
I have a 1990 and it is driving me crazy everthin has worked great for years but now after running for a bout five minutes the temp control starts flassing and I can not cotrol the heat or air I turn on the air and it will turn on the heat after a little bit or it may turn on the fan and if I...
Did you blow out your cooling lines ? also some manufacures put a check valve at the cooler as to stop drain back it can become cloged not for sure if that model has one but you should always flush out your cooling lines Also did you change your torque converter ? this should also be changed it...
HELP !! anyone changed there clutch or flywheel duel mass
Ok I know someone has already done this my clutch was slipping so I pulled the trans not easy to say the leist.How are you supposed to get the trackbar off the manuel says move it to the right and then down well it will not fit with a...
Has anyone tried to ballance there tires on the inside like Inavative Ballancing ? I have done this on my one ton duely and it works great,the faster the smoother.I am about to put new tires on and was curius if it would work on low profile tires.:confused
Anyone running long tube headers ? If so do you hsve any isues with the collectors dragging over stuff.I would like to put a set on but I already have place's where I will drag because of the ground effects from the Greenwood pieces under the doors.
Merry Christmass !!!!!
Thanks for the info I will try it.Its good to know where you can find good help !!! Your cars look great I need to get some pitures of mine when weather permits.Thanks again.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.