Welcome to the Corvette Forums at the Corvette Action Center!

Recent content by BOB SWEETING

  1. B

    NCM's 2011 November Monthly Calendar

    1991 zr-1 museum piece? I purchased new one of the 92 Turquoise Metallic ZR-1 cars. It was a Chevrolet show car at the L.A. Auto show in 1990. This car has been faithfully taking me on many adventures, and now has over 250,000 miles on it. It has to be one of the highest mileaged ZR-1's in...
  2. B

    Post a Pic of your ZR-1

    Zr_1 photo iF YOU CLICK ON THE PHOTO, IT WILL ENLARGE. THE WHEELS ARE JUST LIKE THE EX CAR EXCEPT I PAINTED THE SLOTS TURQUOISE. THEY CAME OFF THE SER NO. 55 CAR.
  3. B

    Post a Pic of your ZR-1

    Bob sweeting's 1991 zr-1 ser. No 334 car has 1989 zr-1 wheels on it with scoops painted to match body color. Wheels dated 2/1/88 car now has over 250,000 miles on it, still shreds the tires. I bought the car new, but it was used as a cherolet show car. Ppg prototyped this color on their 1988...
  4. B

    1990 LT5 motor for sale $3000.00

    Lt-5 motor Is this still available?
  5. B

    Finally Bought A "ZR1"

    Zr-1 daily driver My 1991 is one of the 92 Turquoise cars built, ser. no. 334. This car has 240,000 miles on it. It has had things like the water pump and alternator replaced, along with u-joints, and everything that spins, but the engine has performed flawlessly. It has stainless headers and a...
  6. B

    I NEED HELP brake problems

    Brake problem Jack it up, and check for any loose wheel bearings, especially the rear. Those masters last 10 years or more. We use them all of the time for street rod and muscle carseyand never a problem. Rotor run out caused by improper set-up on a lathe will ruin rotors, sometimes they end up...
  7. B

    Question: Power Brake Booster Bad?

    Booster Sounds like the booster is bad. Powerbrakesonline.com can rebuild it for you.
  8. B

    1976 corvette brakes

    Brake problem It is rarely the rubber hoses. GM put on several million of them. A low pedal is either because of loose wheel bearings, or the caliper pistons are pulling back due to improper positioning of the boot on the piston. IF that is good, I.E. NO clearance between the caliper piston and...
  9. B

    Help Brakes Problem

    Brake pull The obvious one is there is brake fluid leaking on the opposite side as the pull. The wet pads have no friction. The less obvious one is that the frame has cracked where the front lower a-frame bolts onto the main frame. They crack there, especialiaaly with an automatic trans.
  10. B

    Question: Replacing the factory Bose radio

    Bose radio A company, Custom Autosound has finally developed a Pioneer replacement unit for those cars. Their phone is 800-888-8637
  11. B

    Does anybody need a rare set of 89 ZR1 Rims??

    89 zr-1 wheels Curious, what did they sell for?
  12. B

    A fast visit to world's only Corvette assembly plant, museum

    240,000 mile 1991 ZR-1 #334 I bought my Turquoise ZR-1 new in Dec 1990. It was 1 of 92 ZR-1's built in that color. I have loved this car so much, and taken such great care of it, that it has achieved a milestone (I think) of 240,000 fun loving miles. The car is still beautiful and runs as new...
  13. B

    Performance Brake Upgrades

    HYDROBOOST CONVERSION We (POWER BRAKE SERVICE) were the instigators of the use of the hydrobosst on muscle cars and street rods, many years ago. Most of these cars had bigger cams which lowered the vacuum available to produce the high pressure needed to operate disc brakes. Many cars were...
  14. B

    Curious about performance upgrades

    HYDROBOOST SYSTEMS DID CHEVROLET OR MERCURY MARINE EVER MAKE HIGH LIFT CAMS FOR THE LT-5? IT WOULD SEEM TO ME THAT .390" LIFT IS PRETTY LOW IN THAT DEPARTMENT. THE DURATION IS NOT THAT CRITICAL DUE TO THE DUAL PATTERN LOBES, BUT THE LIFT IS WEAK. I KNOW THAT THE CAMS ARE RETARDED TO DROP...
  15. B

    Master cylinder

    HYDROBOOST SYSTEMS THAT MASTER WILL WORK FINE, BUT CHECK ALL OF THE OULET PORTS FOR THE CORRECT LINE SIZES, FIRST
Back
Top Bottom