Welcome to the Corvette Forums at the Corvette Action Center!

Recent content by bobder41

  1. B

    Question: Hole in Floor

    Thsnks I will give it a try.
  2. B

    Question: Hole in Floor

    Apperantley my wife took my 1990 coupe and had the oil changed 3 months ago. Yesteday, I had to change the battery, when I went to the bottom of the car to take the kick plate off I found a new hole in the floor. It is in the left front corner of the foot well, it is about an 1.5 inches round...
  3. B

    Check Gauges Light

    My 90 L did the same thing. All of my gauges are reading fine but the light came on. I do not drive mine much 50k miles but one day it came on and would come on 15 min after starting the car for several occasions. I had my alt ck and it was OK, temps ck and OK. Pulled and reinstalled the...
  4. B

    I think I broke my AC

    In addition to redvet advise. have the shop do a leak survey to find the leak in the system. Repair or replace the defective item to avoid another problem. It is cheaper to fix the problem now than blow another compressor and doing it all over again. Redvet is right about the R4 not handling a...
  5. B

    Check Gauge Light Comes on 90 l98

    thanks but the service engine soon light did not come on, also the computer did not store any codes
  6. B

    Check Gauge Light Comes on 90 l98

    I have a 90 L i bought last Sept (55000 miles). The owner of the car put 4000 miles on the car in 12 years, he had a dealer maintain the car once a year. When he had the car checked out in Aug of last year they replaced the computer located by the master cylinder and battery. I drove the car...
  7. B

    at the car wash........

    I wash my 90 by hand. Freind has a 92 and his wife took to an autowash and it got stuck inside on the track (to high) $3500 later car clean and boby repaired.
  8. B

    Thermostat poll, 160 vs 180

    180 with ? I would like to run a 180 stat in my 90 L98. I belive to 160 is too low for normal hwy driving. I am running a 195 now I am trying to find someone that program the chip to have the main fan t-on at out 210 instead of the 230 temp the factory has set. If anyone can supply me with a...
Back
Top Bottom