Welcome to the Corvette Forums at the Corvette Action Center!

Recent content by CHRLDO

  1. CHRLDO

    Help! Problem with connection between ECM and Scanner!

    At that point I again contacted tech support and explained that under the circumstances I wanted my money back since the tool would not function as advertised, they indicated they would send another new scan tool for me to try before throwing in the towel and refunding my money. Amazing as it...
  2. CHRLDO

    Help! The engine suddenly dies

    yes thanks! the brain was shutting down by the time i posted! (IAC) Idle Air Control
  3. CHRLDO

    Help! The engine suddenly dies

    check the intake air control. it doesnt throw a code and symtoms match.
  4. CHRLDO

    94 vette distributor

    did you buy the car? the new vented version will have 2 small hoses usually going to the bottom of the opti and being routed up the drivers side of the engine. drawing air from the snorkel thru the opti via a vacuum on drivers side of intake. just dont hose the engine down till you can prevent...
  5. CHRLDO

    Battery keeps draining

    i had same problem! disconnect the positive wire at alternator and test. i had a short in the insulator where the connector goes thru alternator case. chuck
  6. CHRLDO

    clutch problems

    you say the master cylinder is full ,(brakes?), are you referring to the reservoir for the hydraulic clutch? mine is a 92 coupe and you have to remove the ECM and bracket to get to it.
  7. CHRLDO

    Rough Ride in my 93 with SRC at any Selection.

    mine is a 92 and i've worked on one shock. you can remove the control from the top of the shock , hold it so you can look inside with a light , while looking into it have someone turn the key to the on position . you will see the gear move. this will throw a code . no special alignment required...
  8. CHRLDO

    Service ASR light

    i had the same problem on my 92 , it was the front speed sensor connector. i forgot to reconnect after removing inner panels to do plugs and wires. the wire goes from front wheel hub thru opening in inner wheel well and is plugged into a connector after it passes thru the opening. connector is...
  9. CHRLDO

    Help! Instrument Panel/Central Control Module

    Similiar problem cleaned and tightened ground above oil filter and ground to bell housing bolt --NO LUCK! i think its the ecm , when speedo isn't working car isn't running right. might be a bad solder joint that expands when car heats up.
  10. CHRLDO

    Digital dash rebuilders/parts

    www.corvettecentral.com
  11. CHRLDO

    Help! Instrument Panel/Central Control Module

    Similiar problem thank you!, i'll start with the engine ground. you've been very helpful,THANKS!
  12. CHRLDO

    Help! Instrument Panel/Central Control Module

    Similiar problem the speedometer on my 92 coupe works fine till car warms up then irratically goes from current speed to "0" and then to any number in between then "0" or maybe the correct speed. i think it's the ground. the service manual shows it to be on drivers side between back of engine...
  13. CHRLDO

    Before & After rims.

    did you post finished photos of wheels? i'd like to see the final product .
  14. CHRLDO

    Wanted: Ride control module for 92

    thanks! there were 5 modules , but none for me .
  15. CHRLDO

    Wanted: Ride control module for 92

    PART#22114171 anyone out there have one? it's a 92 coupe with fx/3 ride control. it's in storage compartment in floor behind drivers seat. thanks
Back
Top Bottom