Recent content by Deadlego

well i found out today its a 2001 but it needs a BPMV and the EBCM so.... I need to talk to the owner and see whats the best price she can do for the car.

Yea thats what I was thinking. So if the car is older then 79 then the shifter was aftermarket.....

What was the 1st year for a six speed in a corvette?? I have friend who told me that they have a 6 speed in there vette but its old then 1979. They will not tell me a year but they did tell it was factory. All I could find is a 1989 was the 1st year for a six speed. Now Im not sure if its...

Thanks for all help and hints. I got the clutch changed. But I did break oil temp unit thing. What a mess.... Any way its done and seem to work.

Ok thanks for the information. I will doing the cutch tonight if I get the parts today. I have parts ordered and they should be here today so. Agien thanks for the information Steve

I dont have the shop manual. So any hints would nice. Thank to you guys for help. :D

Wel I have a 1979 L82 with the 4 spd trans. Now do I have to pull the engine to do the clutch or can I pull the trans out? I have a fixed crossmember so I cant unbolt that. I have some people telling me I cant and then I some tell me I can. So Im not sure what to do.

Well I went with the Sachs clutch kit. I was thinking about the Centerforce but right now I need the car and well my money is tight because of college. It just su8cks that now I have to pull the engine to do the dam clutch...... To let you all know Im certified in Collision repair. Im...

I think I might go with a Sachs Clutch. I found a OE replacement one at a local auto parts store for $170. Thats not bad price. I have heard they are good clutchs.

What about LUK or RAM clutchs?? Has any one used them?

I have a 1979 L82 with alum. head intake ect. The car is 4spd and the throwout bearing is bad. So I want to do the clutch but im not sure on what manufactor of clutch I want to get. Also I was thinking about upgradeing to like a stage 1 or stage 2 clutch. Do you have any recomdiations?

Did you all have to move the motor mounts? I have been thinking about this. but not sure

well my half shaft is shot. I had a u jiont that was shot and now the new u jiont will just push out of the yoke. So Where a good place to get a half shaft at??

Well I have 1979 L82 with 4 speed trans. Now here the problem is that the rear is makeing noise. Im not sure if a u jiont or a spindle bearing. Its make a cracking/grinding noise. Also when turning the wheel the trailing arm will jump when it hits one spot. So I think it might be the ujiont...

sent you pm