Acquired a '98 and working through some minor issues with it. The third/center brake light wasn't working and was setting a C1295 code and disabling TCS when the hazards were triggered. I removed it and found that one of the legs in the connector was broken, so I replaced it. But, it's still...
Thanks for the suggestions Daniel, but it all may be moot. Wanted to update on this, the first thing was that once I removed the chunks I found in the oil and let the oil drain off of them for a day, they didn't look like bearing material at all. It was metal, but it was so fragile it crumbled...
I don't drag race anymore, Hib. This car is all street driven. It has 235/40 series Falken FK-452's on 18's.
The 282 runs RP synthetic fluid and has output shaft support bearings and no rubber mounts. This keeps the aluminum case from cracking and helps the spider gears survive the added...
Great questions Hib, I get asked that a lot. As far as traction goes, there are two mechanical reasons that a Fiero has inherently better traction properties than, say, a car with a front engine/rwd layout. The first is the most obvious - with the rear-mid engine configuration, the most...
Yup, it is... full disclosure, it's an '88 Fiero with an SBC V8 conversion. Again, like I said, didn't want anyone to lose sight of this being an engine problem, but now that I've figured it out, there it is.
This happens at a somewhat disappointing time because I just got the bastard running...
I never said it was an '88 Corvette. The gages in it are all analog. It's just easiest to think of this as an OBD-1 LT4 engine with TPI, because the car is a hybrid of so many things that I don't want anyone losing sight of the forest for the trees, know what I mean?
The oil pressure is now...
My car ('88 with 350 GM crate ZZ430 w/ '91 TPI) has been down for about four years during a long-term project to upgrade to headers. Once I got it back up and running in February, I noticed my oil temp gage was running high. It would start out normal for the first few minutes, but then...
The shop owner wants to try a different fluid that he's calling "Impact" by MTL. I did some googling and it looks like MTL is a Red Line brand, but there's nothing made by them by that name. He says it is a heavier oil that can even quiet a ZF. Anyone heard of this before? I'm concerned about...
The other problem is first gear's engagement is stubborn. intermittently as I'm engaging it, It feels like it is going in about 3/4ths of the way then it either refuses to go any further and pops back out to neutral as I release the clutch (then grinds like an SOB going back in again) or takes...
Thanks to everyone for the suggestions. Junkie you're amazing, nailed it as usual. It actually does make the same noise in 5th, it just isn't as prevalent because of the 2000rpm minimum. I haven't had the chance to test it in 6th yet (har-har, who here knows how fast you have to go in 6th to...
I had my tranny rebuilt, but now it has this annoying whine in 1-3 from 2k rpm+. I don't know what the shop filled it with, but is this something that the right fluid can fix, or does it need more than that?
Trying to find pics & videos of '94 museum parade on I-65...
Did some searching on Google, YouTube, Yahoo and VetteTube and haven't turned up anything of the parade down I-65 into Bowling Green. Anyone know where that footage has gone?
Thanks,
Dave
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.