Welcome to the Corvette Forums at the Corvette Action Center!

Recent content by Donne Trav

  1. Donne Trav

    HELP! No Start In Wet Weather!@#$%^&&*!!

    My '94 6spd will NOT START in wet weather! Usually, after sitting for a few days — in dry weather — it will crank. This happens frequently. As much as I truly love my Vette, I sometimes feel like driving it over the mountain side. Just kidding. Can some body please help me. Thank you.
  2. Donne Trav

    For Sale!!

    1994 Corvette — "Drivers-side" Window Switch. Recently bought off E-bay! DISCONTINUED ITEM! Very hard to find! Thinking I had a bad switch, I finally found the only window switch I think is in existence! That was over a month ago! Later I found that my window motor was bad. I have replaced the...
  3. Donne Trav

    Help! '94 Window Motor Test?

    Is it necessary to remove "window relay" to test motor? Window switch was been tested — found to be bad —and replaced — drivers side window still not working? Thanks
  4. Donne Trav

    Help! '94 Window Switch??

    Once I gain access to the "driver side" window switch (operates both windows), how do I test & clean this switch to see if it is OK? The switch is presently disconnected from its wiring. Is it necessary take the switch apart? I see that it has at least two parts or pieces. Electrical issues are...
  5. Donne Trav

    Help! Drivers-Side Window Motor?

    Is it necessary to remove the window relay/motor unit just to CHECK or REPLACE the motor? Thanks
  6. Donne Trav

    Help! Drivers-Side Window Motor?

    Hello. I need to check and possibly replace the driver's-side window motor. I have removed outer panel, etc., but the motor/regulator are hidden by an inner metal panel. What part of this seemingly 2 - piece metal panel do I have to remove. There's the large — dark colored piece that has bolts...
  7. Donne Trav

    Help! 1994 Drivers-side Window Motor?

    Hello. I need to check and possibly replace the driver's-side window motor. I have removed outer panel, etc., but the motor/regulator are hidden by an inner metal panel. What part of this seemingly 2 - piece metal panel do I have to remove. There's the large — dark colored piece that has bolts...
  8. Donne Trav

    Help! Drivers Side Window

    Suddenly, my drivers side window won't work. I noticed a few weeks ago, after it rained, it would work only if I held the switch while slamming the door, I could get it to move slightly — eventually getting it to operate. Now after another hard rain, it won't operate at all. It's stuck in the...
  9. Donne Trav

    Help! Valve Cover Grommets?

    How do you remove the rubber grommets that run down the center of the valve covers? Thank you
  10. Donne Trav

    Help! Drivers Side Valve Cover?

    Hard To Remove Drivers Side Valve Cover? Re: 1994 Corvette LT1 I can't seem to get my "drivers" side valve cover off! There's not enough clearance because of the AC & Alternator bracket! Is it necessary to pivot the bracket out of the way. Also, will these units remain in place (not budge)...
  11. Donne Trav

    Help! Oxygen Sensors?

    How many 02 Oxygen Sensors are on a 1994 LT1? I've seen in reference, "bank 1", left sensor & right sensor and "bank 2", left sensor & right sensor. So, are there 2 sensors EACH SIDE (left & right) for a total of 4? Very confused! Thanks
  12. Donne Trav

    Question: Your Code Reader/Scanner?

    Specifically, what brand CODE READER do you use on your '94 LT1? About how much did it cost? Thank you
  13. Donne Trav

    Question: Code Readers/Scanners??

    What Code Readers/Scanners are you guys using on your vehicles? I'm looking for a "good" one for under $200 for my "94 6 spd LT1. Thank you all.
  14. Donne Trav

    Help! Radiator Fans??

    On my '94, the "RADIATOR FANS" and the "SERVICE ENGINE SOON" light come on. The engine hasn't even warmed-up yet. The coolant is at the correct level. What's going on?? Please help. Thanks.
  15. Donne Trav

    Question: 160 or 180 Degree Thermo?

    How can you tell the difference between a 160 degree thermo and a 180 degree thermo? Thanks
Back
Top Bottom