My heads were redone. I probably should have mentioned that. I don't know all the specs anymore. I know they have hardened valve seals and some other valve work done. I'm pretty sure there are stiffer springs and the valves may have been enlarged. I recall him saying something about a port...
I don't have the original engine or quadrajet in the car anymore.
The Pistons are flat tops. I'm not sure about the reliefs.
Sent from my iPhone using Tapatalk
So it appears the baffles my edelbrock valve covers are hitting my roller rockers. I can't fit tall valve covers due to clearance, so I will have to remove the baffles.
Has anyone ever used a pcv valve with an internal baffle? I've seen a couple sets on eBay and speedway motor sports sell a...
Thanks for the replies. I'm reading the rocker link now. If all else fails I'll remove the baffles and put an inline filter in the pvc hose.
Sent from my iPhone using Tapatalk
I'm almost done with my 355 project. I finished adjusting the rockets and installing the intake last night. I started to put the valve covers on and ran into a problem.
The valve covers go on, but it appears the baffle is hitting where it slides between the rocker arms. I noticed a lip on one...
I'm in the process of removing my break booster on my 74. I've disconnected the master cylinder and have all 4 bolts loose from the break booster. I've removed the clip from the pin holding the break booster to the pedal. How do I remove the pin? It won't turn or push through. The one side has...
Engine runs much better after plugging booster. Shifts normal again too. Will a break booster off any other vehicle fit or is it corvette specific?
Sent from my iPhone using Tapatalk
Well the evap canister doesn't appear to be connected. The hose to the fuel line is there. I plugged it back in, but the carb line is nowhere to be found. Which port on the carb does this go to? I have two on the front. One is plugged and the other goes to the vacuum advance. I'm guessing it...
Lol. You're in for a treat. The breaks are a bear to bleed. I'll have to double check which one to bleed first. I think you do the front one first. Otherwise you'd get air in the back when you break the front one open. I'll double check and let you know.
Sent from my iPhone using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.