Welcome to the Corvette Forums at the Corvette Action Center!

Recent content by Gasman

  1. G

    Adding sun visors

    can you post a picture, i need to get to mine someday. thanks, rick
  2. G

    My absence from the CAC lately

    Put a C2 plate on it and it will be correct.
  3. G

    Under Dash Question.

    Thanks Claude. Exactly what i needed. my rods have holes in them, my support didn't. i thought they would be bolted in with the T bolts from the window. now i need to get them tac welded to the support or drill some holes in the support rod. rick
  4. G

    Under Dash Question.

    In my 61 AIM Section B Sheet 11, it shows 2 support rods. it looks like they go from the body to the under dash support and help hold the windshield. If they do, bubba might have changed the angles on my supports. They sure don't seem to want to fit real good. can someone enlighten me or post...
  5. G

    Clutch pedal problem

    It all comes down to clutch fluid. Keep it clean!!!! One vendor sells a hose to connect to the bleed connector that routes it up next to the resevoir. That is the easiest and best way. After replacing my clutch master and slave for over $1100 and having it get spongy again after only 15,000...
  6. G

    1961 technical stuff

    That sure is close to my number 2346. But then I don't know any history. rick
  7. G

    need photo of C1 '60 with fuel injection emblem on fender...

    Herb, we'll make you the templet keeper. lol rick
  8. G

    need photo of C1 '60 with fuel injection emblem on fender...

    Stop! Sent the templet for my 61 side emblems. (top and bottom are bars and the middle is corvette). Nolan shows your 60 to only have flags in this area. Pulled my emblems out and the Fuel Injection is higher up. i still have the holes on one side so i'll make another templet. these stayed...
  9. G

    C1 - Anyone had experience with replacement/after market SS trim?

    Bought the upper winshield chrome from Grosssmueler about a year ago. first one i found then and it was $600. hope they are in production now. i was told it was one of the harder pieces to find. rick
  10. G

    need photo of C1 '60 with fuel injection emblem on fender...

    The chevy body mouldings and attaching parts manual has a view of where they go. No measurements there. I looked on mine, which i haven't started reassembling and the holes have been covered. But.....the inner wheel wells still have the remains of the holes. if you need, i'll make you a...
  11. G

    C1 window removal

    mine came totally striped out. i need to find out if i have all the parts. take a lot of pictures for me please. rick
  12. G

    Removal of a Rear Bumper Bracket on a 1961 Vette

    It will come out with the body off. It just floates in there till the rest of the bumper brackets secure it.
  13. G

    Removal of a Rear Bumper Bracket on a 1961 Vette

    The only way to get it out is with the body off. I learned this when i forgot to put it in and put the body on, then had to lift it about a foot to get it in and drop the body again. rick
  14. G

    C1 - Is your door lock linkage hooked to your accelerator pump?

    At least you found them. since i did'nt take my car apart, i'm finding how much i really need. rick
Back
Top Bottom