Recent content by glen242

Q-Jet Why not send it to LARS for an evaluation?

What would be considered, in your opinion, a high-performance application? What reason should DOT 5 not be used in a strictly street and/or weekend drag strip vehicle, such as a C3?

Performer intake should allow for the stock air cleaner use. I used one with stock hood and factory air cleaner set up for years, before replacing with a Performer RPM (high rise) intake. RPM intake is taller and requires a drop base air cleaner, then, unless you fabricate a setup, you loose...

The 'Myth", as you call it, is really true! Performer RPM will NOT fit under a stock hood when using the stock air cleaner. You can attempt to use after market/modified air cleaners to get a fit, but I have not heard of anyone running stock, from the factory, components and having it fit...

Dr. Rebuild Willcox

Look at the PADOT sight for inspection rules. Although, maybe, 25 year old cars don't need a tube-up-the-pipe, the visual checks still apply, unless you have Antique, Classic, etc. licence plates. I have Classic plates. No tail pipe check, no visual inspection. I do get a yearly Safety...

Don't forget, the amount of quench you have can determine if you have detonation. I believe ideal quench is 0.038 to 0.045. Mine has 0.041 quench with my '0' deck block.

Timing I have run a stock recurved HEI distributor and now run an Accel recurved distributor in my modified '76 stroker. I never cared or recorded what the initial timing was, only set it for 35* all in at about 2600 rpm. Per Lars' papers, I picked a vacuum advance unit that would give me the...

Rather than using a pressure bleeder, I use Speed Bleeders (all 6 of them) and have had excellent results. 6 Speed Bleeders are quite a bit cheaper than a power (Motive) bleeder.

I have been using Valvoline VR-1 10w-30 in my stroker with a CC XE274H cam since I built it, about 5 years ago. Prior to the stroker, I used VR-1 in my 350 with a CC 268H cam. Never had a problem with either engine. VR-1 has the Z and P that my flat tappet engines require. It also has a...

Since the engine is out, have the block decked. I run a '0' deck blocked with a 0.040 head gasket. On my 383, static CR is 10.30, cam is a CC XE274H and I run TF aluminum 64cc heads. It runs fine on 89 octane pump gas.

I am in Western PA, near the airport, and I use a local shop for my 4 wheel alignments. They also let me wander around while they are working on it and have no problem showing me the specs they get. Last alignment I got was $120 + parts. I do take in my own rear shims as they are Corvette...

Look under the car and see if your crossmember has 2 holes for the 2 pipes. I know that at some point the 2 holes were discontinued. My '76 still had the 2 holes but, a '74 bracket was still needed to hold the 2 pipes. What transmission is in the car? Autos have a removable crossmember.

Your '75 should have 2 holes, as does my '76. Stock exhaust, long gone, had the the Y pipe with 2 holes in the cross member.

I purchased a thermostat housing that had a provision for screwing in a temperature sender. I have a '76 with a performer RPM intake. I believe that I will purchase a Derale adjustable fan controller (#16749), as I do not like the on/off range the fixed sender has.