Recent content by gms

What is this on top of the air pump. I do not see it in my 1980 manual and have not seen it in any pictures of 1980 engines. I thought it might be a check value. What is a replacement part? Thanks for looking

Just purchased a 1980 Corvette. My passenger side headlight does not open. If I move it manually it comes up about an inch in the front and then the rear of the door hits the opening. If I press down on the body directly behind the door and turn the lights on it opens normally. When the door is...

I bought a Intake Air Temperature (IAT) Sensor Relocation kit from Corvette Central. The instructions say to mount the new sensor where fresh circulating ambient air can be found. The new sensor has a bracket that will need 2 small holes drilled to mount. Can someone give me a good sensor...

Forrest thanks for responding. The 6060673 is doubleside - mine is flat on one side. I checked www.daycoproducts.com and see the 6060673 is 67.25 long. The Dayco 5060670 is 67 long. On www.daycoproducts.com if I search for 1996 Corvette LT1 is comes up with 5060670. I ended up with a Goodyear...

Goodyear 4060672 works I tried warming the 4060670 in dryer but still could not get it on. I tried a Goodyear 4060672 and it was tight but I got it on. The 406072 was a little shorter than the old one I took off. Not sure why the correct part would not work. I was able to move the tensioner...

The new belt is marked Dayco 5060670 I found it at Corvette Central item 304564 What is the last pulley I should be putting the belt on? The alternator has ribs - so it is hard to get over the flange. How can you see markings on the tensioner - it is down under the water pump? This is the...

I searched the forum and read many of the posts on installing the serpentine belt and thought it would be easy. I bought the special tool and can easily move the tensioner thru the full swing and removing the old belt was easy. When comparing the new belt to the old it is about 3/8 shorter. I...