Hib the 90 does not have a mill code. My 91 at times sets one at times, pin pointed to egr vacume switching valve, and when i saw that the vacume switching valve to the egr was hard to find it got me thinking if something like that happened to the 90 and the part became unavailable what would be...
Hi Hib, on my l 98 car vacume switching valve for egr on a 91 getting tuff to find. The reason i ask i am getting ready to get a 1990 ZR1 and since it is getting older and some emissions parts are getting hard to come buy i was wondering if the CEL came on could you bypass so the engine would...
I have heard a 1990 ZR1 will not run in full power mode if the check engine light is on. My question is if you happen to have one and the CEL is on is there any way to bypass this. The reason i ask is i have a L98 car and some parts that can set the CEL are not available any more.
I just purchased a 1991 corvette. I am going to replace the clutch master and slave cylinder. I do not have any key fobs for this car yet. My concern is after i remove the battery to do this job when i reconect it will the alarm go off. If it does will i be able to disable it any way with my...
I did not get my ebrake adjusted this weekend. The radiator install burned me out, was more of a PITA than i was expecting. Next saturday i will adjust the ebrake and do a wheel bearing repack.
My e-brake also stinks which i really need since my car is a 4 speed. When i adjust e brake i do like was stated above spin the wheel adjust the star wheel till i feel a little drag. I was reading an article yesterday talking about a design flaw with adjust e-brake on a c 3 because of the...
I am ok with doing the rebuild I am a mechanic at a toyota dealer. I have had no luck with finding different gear ratio's for the m21. If i rebuild my m21 I will replace the fist gear back to original 2.20, but was thinking i may be better off with a m20 for a more street friendly first gear...
I priced out a rebuild kit for my m21 and including purchasing a first gear cog am looking close to 400. I will do the labor myself if i go that route.
I think the whine may be a little excessive. I also am not crazy over the first gear ratio of 2.20. So realy dont know if i should rebuid it and replace first gear. Have considered swaping to a m 20 for the better first gear ratio, or doing the 5 speed swap. If anyone has done any of these...
My 74 has a M21. Trans shifts normal, but in first gear when i accelerate i get a whine noise, only in first. Is this normal. Is first gear a straight cut gear which is making the whine or is this a sign of a problem. Thankyou.
This may not be correct but i am sure someone has input on this thought. If you have a 81 and want more power and a lot of states do not require a check engine light function for emissions inspection on such an older car could you not bypass the engine ecu with a carb and distributer change and...
I just purchased a 1974 convertible 4 speed car. My problem is that it only has lap belts and i would much prefer a 3 point seat belt with retractable shoulder harness. Does anyone no of a good sourse for this or a good aftermarket set. My other concern if i find a seatbelt with shoulder strap...
I figured the two cars would be similar in performace, but that 1991 i drove had something wrong with it felt like a L98. I hope this car does better looked at it yesterday will drive it tomorrow or saturday. What are the obvious signs of bad injectors i guess it would be a miss or i may get...
Hib i dont know if this is correct and applies to chevy, but on toyota if the idle starts droping real low you can dissconect the battery and clean buildup on the throttle body to restore proper idle level. I have heard that on some cars you can not clean the throttle body for risk of removing...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.