Looking for a passengers side flip-up arm rest with or without bracket for my 1995 LT1 C4
The plastic that the pad is molded to and screws into the flip plate has crumbled and no longer supports.
Or, I'm open to a "Fix", if anyone has made a replacement option. (?):upthumbs
95 C4 LT1 Major Hesitation/cut-out from stop.
I had a similar problem before and replaced the throttle body plate gasket and it worked. However, that doesn’t seem to be the problem this time.
When engine is hot (190) and I give a hard acceleration from stop position, it hesitates and pops...
I’ve been away for a while, but I’m back—and back with an irritating problem.
Question: How do I disable the PKE?
Situation: When I bought my 95 Vette it came with no FOBs. The PO had a Viper alarm system installed which has its own FOBs, so I never bought any. Lately, my PKE light comes on and...
I’m contemplating putting a Borla exhaust system on my 95 C4. I'm generally interest in the sound and any performance benefit would be a windfall. Will I get a pretty good sound (compared to current stock exhaust) without headers?
Any comments/suggestion would be greatly appreciated.
Thank you...
Thank you hcbph.
I'll take a look at RockAuto. I've purchased many parts from them in the past and had good service.
I mainly cruse (Sunday Driving), no rat racing, etc...
The roads where I live are not the best. Many poorly patched pot-holes and rough areas. I noticed when in a turn (and...
BRUTE86,
Thank you for the details. It’s been 30 years since I’ve bleed brakes and I can’t recall if I even did it correctly back then.
One question. I am going to replace the brake hoses, as I noticed cracks and chunks of rubber dry-rotting off of them when I replaced my back brake pads.
Will...
I would like to change out and replace all brake fluid and lines. I intend on replacing my hoses with steel braided ones all the way around. What is the best method for doing
this and ensuring a brake bleed that will work best? I have a hand-held brake pump but have never used to to breed brakes...
I am just curious at this point, as I have depleted my car allowance for the next six + months… Borla or Corsa exhaust system – which is the best and/or has the best sound?
I have not (and have no early plans at this point) made any modification to the motor/trans, just stock for now.
However...
Thank you all so very much. I lean something every time I read your comments.
Taking the advice of changing my brake fluid, which I think is an excellent idea, what is the better/best brands of fluid I should consider?
DOT 3, correct?
Again, thank you so much for all the help.
I am so glad I...
Great Rotor Info
BRUTE86,
Thank you for that information. I was wondering about that possibility, as I had hear that from other vette drivers.
I am a Sunday driver. I drive the car no less than once a week and try my very best to avoid driving in the rain or on wet roads. I live way-down-south...
Red Books
Yes, I got both volume 1 & 2. Volume 2 is very techical and mostly over my head. However, my brother-in-law is an electrical engineer. He's alsop a Mustang fan, as he recently restored a 1969 ground-up to factory condition. However, with a little smooth ego building-talk I could get...
Thank you CAC members.
I finally found some used ones in really good shape. $94.00 shipped. I thumb through them and all the pages appear to be there. A few grease marks, but that just tells me someone at lease used it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.