hello peer and rc. i didnt see you previous question about who the diverter repair man was. his name is darin. i have his phone number if you need ill pm it to you. peer, im still working on my divertwer. i chose to cut it open and repair it myself with a little help from darin. the parts are on...
with all that stuff removed how is you computer not giving you a check engine light? do you have an o2 sensor in the new header? its probably not working at all or the check engine light has been removed. most guys who have gone that far replace the carb with a non ecm carb or they modify the...
without the air management system in place, and if the computer is still functioning there is a problem. my system works great. its a good system that is what makes an l81 an l81. sorry for any confusion. the performance check will not help you after the engine has been altered. replacing that...
hello. do you have the service manual. its clear on the course of action you should take. along the flow chart starting at a performance check will lead you to your problem. after the performance check move on to air management system check. plug the headlight circuit and do a performance check...
okay then. like mikey said remove the headlight circuit from the manifold and cap it to eliminate the entire headlight system from the engine. just cap that tee where you remove it. then do a system performance test. page 6e1-11 of gm manual. if you dont have this i will send it to you in a...
hi antz sound like you doing what i just got done doing. do you have a mighty vac or similar vac gauge/pump. did you spray wd 40 around the carb base gasket and the intake manifold where it meet the heads with the engine running? the dwell can be set. make sure you confirm all the leaks are...
update
for anybody who cares. i have found a supplier who will sell the oem diverter relay for our 1981. he will also rebuild your existing diverter valve. i think i could do it myself and the guy is very helpful if you have questions on the rebuild or what parts you will need to use as doner...
or if anybody has just the relay that mounts on top the diverter. my diverter is okay according to my shop manuals flow chart. just the relay is testing bad. any suggestions?
hello everyone. its been a couple years and i am now living in california. make a long story short i failed my smog. the air management system has failed. the diverter valve is not diverting air to the cat. i need this part and cannot find it. does anybody have one they have removed and may be...
carb settings
hello. i had similar issue and turned out the balancer had slipped. would run but not right. then when it came to full temp it would hesitate and stall occasionally. even though i used a time light it would show it being correct but was timing to a mark that had moved.
when i go to buy new freeze plugs for the front of my engine they are all 1 5/8 both sides of water pump. mine is not. it is 1 3/4 on passenger side of water pump and 1 5/8 on driver side of water pump. reason im replacing is the passenger side was leaking. it had a hole rotted in it. it was...
sounds like to me too. new ecm and swapped proms to see if there was a change. new dist cap rotor coil pickup coil module temp sensor temp sender o2 sensor and no codes. the check engine light works I grounded diag term and got normal flashes for diag mode.
I need some help. I haven't been able to work on my car lately but now im relocated in southern California and am at it again. can someone please tell me why my car runs like crap with the computer connected and runs smooth as can be when the ecm is unplugged completely. hot or cold it runs for...
bill, you sound just like the book. I tested the pickup coil yesterday and it failed. so I ordered a new one brought it home to discover the magnet was for a 6 cylinder. now I cant return it 70 dollars! im going to swap the six magnet for my old one and see if it functions or im gonna have to...
what brown single wire are you talking about. only single brown wire is an oil pressure sensor. yes I have emissions sticker. I was thinking it was an electrical problem. maybe someone else had a similer situation and they could help me pinpoint it. I timed it 6 months ago and its been fine then...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.