Recent content by M20JCorvette

I used SEM interior paint. I bought it a local Finishmasters store. They carry it in 2 different finishes, a low gloss and satin. It goes on easy and matches well. Make sure the material to be sprayed is clean. Silicone or Armour-all will kill the finish. BTW, I just finished putting the...

I was planning on vinyl covers only to save some bucks. This car will never be much more than a daily driver. Good advice on the covers. Did you paint the door sills black or red? I'm trying to decide where to make the color change. John

OK, gang. I recently picked up a pretty rough '86 coupe. I have most of the engine problems straightened out and now it's time to work on getting the interior back in shape. It's a red on red non sport seat leather interior. The seat covers and carpets are shot. Since I never liked the red...

I plan on sending them to Cruzin Performance in MI. They were recommended in another post. I'll let you know the results. John

Well, I just removed the injectors. It was pretty straightfoward. You have to remove the TPI cover and at least the right side intake runners. The hard part was all the vacuum lines and connectors. I'll let you know how it is going abck together when I get the injectors back. John

Eureka! I probably should post this in a new thread for everyboby's reference. But here goes: I pulled the fuel injectors (not an easy task) and bingo - the tip on #7 was cracked and the plunger stuck open!! Now it's a a matter of just getting them serviced. Does anybody have any suggestions...

Fuel Injector causing a miss? Hi folks, I'm new to the forum. I just picked up an '86 L98 manual trans. It was basically a basket case but a good start for a winter project. I could use some advice on troubeshooting a engine miss. When I first got it started (after sitting about 6 months)...