Recent content by Peer81

That's what I call STYLE!! very nice! Greetings Peter

Great to hear and welcome to the CAC! I have the same experience, as living in Holland i can only remember meeting nice and very helpfull Corvette owners over here and on the internet! Greetings Peter

Also remember that the original alu 81 diff only came with a 2.87 ratio. The 3.08 you have are an aftermarket set already and the question is what quality or previous life did they have. Greetings Peter

When looking at Hib's things. At idle or slow speed: 1 and 4 make no difference if the is no or slow airflow. The fan clutch is a good idea and the auw fan right way even better. If would also say. When replacing the clutch fan and putting in a aux fan. Is it pushing or pulling more of the same...

I would say. At the front of the radiator it should push it through the radiator. So if looking at the front of the car if the upper fanblade is at the right closer to the radiator and further from the radiator at the left then the fan should turn toward the passengers side. So pushing the air...

In the past I found one other brand that sells HP HEI distributor. Problem is with the ECM control there isn't to much around. If your other engineparts are stock then just keep it stock i would say. Greetings Peter Verstuurd vanaf mijn GT-I9195 met Tapatalk

Great to hear she fired right up! I wouldn't worry about the old rotor and just enjoy the ride :) Greetings Peter

Hi Gerry, And yes Damn!! I was hoping to hear from you with some good updates! I also think that rebuilding it with a retro roller cam is the best way to go! Greetings Peter

Give it a try. You have to start somewhere :) Greetings Peter Verstuurd vanaf mijn GT-I9195 met Tapatalk

I see it's already 1.5 years ago since I last updated this topic. Well there is not much to say about the vette. It's still in the same spot and I didn't loosen a nut or bolt. On the other hand I bought an average '63 Pontiac Catalina in light blue still original except for the Grand Prix grill...

Any updates on this one? :) Greetings Peter

Sorry no thoughts. Ones I was busy trying to fit a 86 caprice ECM into my 81 corvette (same carb) with a zz4 prom but it still it in a corner somewhere. If it's a simple swap you can always try. But before swapping out the ECM first take a look at the coil and other things. I think it's much...

As the ECM controls the spark lets start with that. As you have fuel and i think enough air the only thing you're missing is a timed spark. Greetings Peter Verstuurd vanaf mijn GT-I9195 met Tapatalk

Maybe the fuel filter. When you have the filter out of the line look if fuel is comming out if you turn the ignition key. And put something under the fuel line so fuel isn't all over the floor. :) Greetings Peter Verstuurd vanaf mijn GT-I9195 met Tapatalk

Sounds great to me! Did you always run the 2K converter or are you changing into it right now? I think with the lockup the 700R4 has it will be a great combo, High stall but still low in mileage because of the lockup in 4th gear!? On the one hand weird to hear it's becomming difficult to find...