I need help trying to figure out how to release the airbag wire connector from the sensing and diagnostic module located behind the ashtray on my 98.
Thanks.
Need some insight on installing magnaflow....
tru-x crossover pipe #15437. It seems the exhaust hangers don't quite line up with the OEM. It's not too bad. I think I can make it work. The other thing is the length of the x-pipe. It's right on top of the oxygen sensors. I would appreciate any...
I just changed the FF on my 98. I have an automatic so once I loosened the sway bar and removed 4 bolts to get the catback out of my way I could get to it. Just be careful, the gas will flow when you start pulling the lines off. The one pictured above is a little different then what is on the...
You don't really have to reprogram them as long as they go back to the corners they came from.
Where are you located?
If you want to come by the house I'll show you how it's done.
I'm at Brownsboro Rd. & Rudy Ln. by the interstate.
The first generation sensor works on 97- 00.
The second generation sensor works 01-04.
To answer your question, the 04 sensors will not work on your 00 C5.
Let's just say anything sounds better then the stock exhaust.
Like jrose7004 said, the Z06 exhaust is much lighter.
I replaced the stock exhaust on my 98 with the Z06 exhaust and I like it. I wasn't looking for loud, just a little more rumble.
As Roc pointed out, everybody has different tastes.
Something's not right.
If the recall has been done you should be able to turn the steering wheel with the key out.
Either GM didn't do it right (Installing Harness & Dummy Plate) or the previous owner(s) didn't do it but told GM it had been done.
You need to call GM and ask them to check their...
Ben,
I would reprogram them again especially since you disconnected the battery. Somtimes it takes 2 or 3 times before it comes out right. Tire sensors are very finicky. As far as the reading changing from LR to RR who knows? I've included a link that gives you the procedure for progamming the...
I pulled car out of storage today and put in the battery. Took it for a ride. all is fine except nothing works on FOB. Is this normal ? There is no mention of it in the manual. Does the FOB have to be retrained ? If so is there a quick way to do it. I assume this was caused be the battery being...
Yes it can be reprogrammed for your car.
Just a note. When you program the one from your friend the one you already have will have to be programmed also. Just do one as FOB 1 and the second as FOB 2 and you should be fine.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.