Well after searching all over the internet and part stores, I was unable to find a sending unit to replace my original one. I rebuilt the old one with new fuel pumps and tank strainer screens for the pumps. Re wired the unit and made sure the pumps work prior to installation. The fuel gauge...
Thank you very much for the link. My sending unit is shot and I bought 2 new pumps to install on the current fuel pump assembly. This will help out with a direct replacement.
Sent from my Moto Z (2) using Tapatalk
Yes I did buy the replacement pumps, in fact I bought 2 kits because I have two cars. However you do not get what the picture shows, you get two pumps, strainer filters and some hardware. I need a sending unit that is completely shot and will not function. I did some research and got a few...
I have owned this 91 Corvette 6 speed for over 18 years and purchased it from the original owner. The car is all stock with just 50.000 miles on the clock and runs like the day I bought. The C4 was a very advanced car for it's time and our still great cars to enjoy.
Sent from my Moto Z (2)...
Good day,
Help needed I have a 1990 ZR1 that does not run and no fuel pressure, I discovered after taking the car apart the fuel pumps are shot and the sending unit is so corroded due to ethenol fuel deteriorating the unit. I am trying to locate replacement parts but no such luck. I was...
Also GM does not recommend putting fuel injection cleanernin these cars because the type of fuel injectors in these cars are the disc type injector and the fuel flows over the coil portion of the internal parts of the injector to cool it down. When you put the injector cleaner in it eats away...
I also have a 1991 6 speed. That had the chatter. The problem was the dual mass flywheel. This particular fly wheel is a dual flywheel that absorbs all the vibration in the clutch area and makes for smooth shifting. The large rubber device between the two flywheels is bad , probably...
The idle position sensor under the throttle body has dirt in between the cone where it seats with the throttle body base. Remove sensor, clean cone area with throttle body cleaner and it carb cleaner. Also spray inside the area where it seats and out back together. There is a small gasket...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.