Search results

I had to use a later evaporator 78 up that used the orfice tube metering.and the dryer reciever. Then I had a local parts store tha specilized in making ac lines. Make sure you "properly flush" the evap and condenser. I used a compressor from an S10 series truck. And converted the system to...

If you say you smell a strong odor of fuel in the garage but see no source. One is the needle and seat are toast, The other is the well plugs on the bottom of the bowl had a tendency to leak. I could be wrong but it sounds like a fuel problem.There is some good information on Q jets, do a...

Long water pumps will work BUT When I put my 383 in I wanted to get away from all the belts. I wanted a serpinetine belt system. I used all the belt drive system from a 4.3 S10 series pickup or blazer. I used the pump, compressor and alternator and aluminum brackets. Now remember that the pump...

I have a centerforce dual friction in my 73,:D with a tremec behind it very satisfied with it.

Msd 6al mounting I mounted mine on the drivers side fender well, just above the vapor canister.on my 73. I am reluctant to previous suggested areas such as in front of air cleaner. As noted in the installion manual, keep away from excessive heat. On top of a motor would not be my choice.

ratio I stand to be corrected,but if you have 411 ratio.and wanted to drop down say 355 you have to change the carrier to a 3 series I forget the break off point For the 4 series carrier

Polishing wheels The dremel tool is good, but your asking it to do a job that is way over its limits. I have done some wheels with a four and a half inch angle grinder. I got the four inch buffing pads at Sears hardware. It is a little tough to get the buff on but it will. used the buff...

Looking for a complete diffrential for 73 4speed With h/d yokes Jack 732 239 5157 Zr2330@aol.com thanks

Stumbled upon Tremec website, as of January 27 Press release. They announced the new TKO-500, Sounds like they made some more improvements. P/NTECT4616 for GM applications. Going to hold off on my order for now, till I know when it will be available. The site is WWW.tremectransmissions.com

I have the flex duals on my 73 383 with air and have had no problems with it

When I put my 383 stroker in my 73 this past summer. One of my goals was to convert to a serpentine belt system. I used off the shelf GM parts. Or you can visit your local boneyard for the parts. Doner vehicle a 91 to 95 S10 with4.3,I used all the components alt/ps/ac. It is a reverse flow water...

Cost me only 60.00 for a line pressure solonoid on my 4L60E

I have a L/H a/c duct. Its a repo hard plastic not like original Make an offer paid 50 for it

I have A pump from a 73 S/B