Welcome to the Corvette Forums at the Corvette Action Center!

Search results

  1. G

    Running out of hope... Starter.

    are you sure your hearing the starter click or just the relay. The relay may be bad ,
  2. G

    Exaust upgrade questions

    Are you suggesting replacing the 90 with a later exhaust ?
  3. G

    C4 Steering problems

    I am not really big on snake oil stuff but before you replace it pick up a bottle of Lucas power steering additive. I had the growling and morning sickness. I put in a bottle of the Lucas and almost instantly it cleared up. That was 9 yrs and 40k miles ago. Still going good. Don't forget to...
  4. G

    Help! Cooling fans run continuously.

    If I remember right the fans run when you jumper the OBD port to get codes, you didn't by chance leave a jumper on ? Maybe not applicable to OBDII which started showing up in 95
  5. G

    Help! Cooling fans run continuously.

    If the air is on both fans should run. Turn the air of if it is on. Wasn't a switch added by previous owner that you turned it on unknowingly ?
  6. G

    stumbling around and worse as it gets hotter here in Phoenix

    No code ? I would check temp sensor and TPS
  7. G

    Crazy Tach!

    I don't use my radio/stereo enough to even know for sure if it works. lol But I am going to look for missing screws , cracks and places where I can insulate to get rid of dash noise.
  8. G

    Crazy Tach!

    Thank you for posting that I need to take my dash apart to replace the heater core so it will be a good time to repair the tach also.
  9. G

    Crazy Tach!

    I have a 90 and my tac has gotten off farther all the time. I did some research a few yrs ago and the tacs in some yrs corvettes have a bank of resistors in them and one or more of those will fail. There is a way to repair them (found on youtube) but is a time consuming project.Have never tried...
  10. G

    Exaust upgrade questions

    You have inspection to contend with so I am not so sure you can alter the way the exhaust is set up. It is set up with a cat on each side fairly close to the exhaust manifolds. I believe 2 1/2 in pipe.This feeds into a 3 in cat and then splits back to 2 1/2 pipe with the mufflers way at the...
  11. G

    Help! Clutch

    Be aware that without the dual mass flywheel setup (no longer available) you may very likely have gear clatter at hot idle in neutral with the clutch engaged. This does not mean there is anything wrong.
  12. G

    Question: ZF S6-40 6 speed manual trans

    If I understand correctly the early model has straight gear teeth and the later has curved gear teeth. I think I read that the earlier version is just a little stronger.
Back
Top Bottom