Search results

Now you've done it! That CE is no longer "original".;LOL

I would pressure test the system, see the link for a typical tool, you may be able to borrow or rent it at a parts store. Amazon.com: Stant Inc. 12270 Cooling System and Pressure Cap Tester Set: Automotive Once pressurized inspect carefully with particular attention to areas such as the weep...

Thanks for catching my mistake Hib, of course you are correct. My mind was trying to find a correlation between the ABS light and power loss issues and I typed ABS when I meant ASR.

I'll assume you are pulling the ABS codes using the method in the link below? C4 Corvette Diagnostic Code Recovery Techniques My 93 FSM shows code 21 to be the RF wheel speed sensor and code 35 is the LR wheel speed sensor. In case you were reading ECM codes by mistake, 21 is related to the...

There should be a vacuum diagram sticker on the radiator shroud.

The General was too cheap to provide a drain plug so most people pump the old lube out with a small hand pump, however it is not difficult to install a drain plug and it makes future service a breeze. See the link below, my post #4 shows what it required. 2 rear end questions - Corvette Forum...

If the compressor is not running system pressure will equalize, so the low side will be above 42 PSI, but it should not be 150. There are no codes above 10 for the climate control so I think you have entered Parameters by mistake. See the procedure copied below. NOTE: Pressing the up or down...

Carefully inspect the hoses connecting the EVAP canister to the fuel tank, those vapor hoses are a frequent source of such fuel odors.

Hate to side with the hated Chevy dealer but I've heard others with the same problem indicate it took a new master cylinder to fix it, I don't claim to know why.

Don't let that step stop you, dropping the trans pan is way easier than removing the tube!:L You can replace the tube with draining the pan, but doing so will likely save a lot of mess.

The bolt that holds the dipstick tube is one of the bolts between the bellhousing and the back of the engine on the right side of course. It can be difficult to get to but not impossible, you can try looking from the top behind the intake manifold, but will probably not have much success. If...

T40 and a ratchet :thumb

The part number is the same from 93-96 (10261112 ) it is still available from GM http://www.gmpartsdirect.com/results.cfm

Customer support number lower right of link. 419-627-0065

From the "What fits my car" tab, top left of the home page, see the second from last entry. 1990-96 Chevrolet Corvette Installation Kit & Accessories for your next car audio / stereo install!

The fly in the ointment is when sponsoring vendors get a poor rating from the members.:L

See the link Car Audio, Faceplates, Wire Harnesses, Antenna Adapters, PAC Accessories and Technical Help - Tune-Town Car Audio

As the others have mentioned the analog and digital gauge readings do not match, the statement below is from page 102 of the 93 owners manual. Gauge Markings The analog gauges provide a quick visual reference to the actual measurements of these gauges. However, they are nonlinear, which means...

Replace the master cylinder, be sure to bench bleed it before installation.

Local Chevy dealer, PN 25521263