Welcome to the Corvette Forums at the Corvette Action Center!

Search results

  1. E

    Question: Vin Number Search

    I found this on the front of the block near the passenger fender. It's on an edge that pops out further than the rest of the block. It's under the alternator. I think this is the right number. I took a wire brush and paint thinner to get the motor paint and grease off. 16NG08222 and then...
  2. E

    Question: Vin Number Search

    I thought that was one long number. lol. I drove the vette to work today. I'll run out in a few minutes and get the numbers.
  3. E

    Question: Vin Number Search

    When I purchased my 74 corvette I was told the block had cracked and they had switched it out with an engine (or maybe just the block) from a 74 camaro. However, after looking at the block I noticed it was stamped 76. I decided to look up the vin number on a camaro forum and it definitely...
  4. E

    WTB: 74 interior parts

    I have a 1974 Corvette with medium saddle interior. I was wondering if anyone had door panels, seats, carpet, ect. If you have any good parts I may be able to dye them. I've also been thinking about switching my interior to black.
  5. E

    Parting out my 1971 vette coupe

    Do you still have the door panels, seat belts, or seats? Also, what color are they? I have a 74 with medium saddle, but I could always dye them.
  6. E

    '68 -'73 parts for sale and needed

    do you still have the door panels, seat belts and seats? What color are they?
  7. E

    A pillar foam repair

    I was putting a replacement radio in my vette the other day and decided it would be easier if the t tops were off. It would give me more light and a bit more room to move around while removing the gauge bezel. Long story short when my friend was putting the driver side t top back on he dropped...
  8. E

    Leaf Spring Replacement

    I found a pair of new 1974 Corvette Leaf Springs on ebay. I was wondering what all is required to install a new set. As far as I can tell the auction is just for the leaf springs. Is there any type of mounting hardware I will need to buy separately?
  9. E

    sbc headers

    I bought a pair of nearly new sbc headers. They came off a 350. I was wondering if headers are generic, or if you have to buy them to specifically fit a certain 350? Thanks
  10. E

    Nitrous

    whom is a reputable company for 1974 corvette superchargers?
  11. E

    Nitrous

    I have a freshly rebuilt engine, so I'm pretty sure it's in good running order. Does anyone know if a supercharger off a 3800 will work or not?
  12. E

    Nitrous

    I've also been looking into superchargers. From what I found Nos is the most "bang" for the buck. I happened to run across a kit on the internet the other day allowing you to use a supercharger off a 3.8L. I didn't think a 3.8 supercharger would push enough psi to account for the large...
  13. E

    Nitrous

    I had a question about sitting up a nos sniper nitrous system. I have an edelbrock performer intake and carburettor. I'm a bit confused about the amount of gas I'll need. I know I'll need to install a larger fuel pump. I'm not exactly sure of the type or performance of the pump though. I...
  14. E

    Help! Truflex rear bumper install

    I found a really good deal on a truflex bumper cover for a 1975. I was just wondering. I know the 1974 had a split bumper. However, the truflex just has a simulated split. Would a bumper cover off a 1975 fit? He only wants $100 for it, compared to a new one that will cost around $350
  15. E

    Help! Truflex rear bumper install

    When I purchased my Corvette the back bumper cover had been removed. They claimed it fell of while they were driving down the road, but I tend to believe they backed into something. The actual steel bumper is still intact and in good shape. It looks like the left side support bracket is on...
  16. E

    Question: Edelbrock Throttle Cable

    What should I be looking for to see if it's mechanical or vacuum? I'm assuming a vacuum hose going from the carb to the throttle body?
  17. E

    Question: Edelbrock Throttle Cable

    I finally got around to installing the throttle cable bracket. It moved the mounting point back quite a bit. I moved the throttle cable back as far as I could. The car definitely picks up speed quicker now, but I still don't hear the four barrel kick in. Is there a way to test the four...
  18. E

    Fuse Box location

    It was up there, but the carpet had somehow got pushed up around it. Wow, I'm not used to seeing glass fuses in a car. I was expecting the two prong plastic type. Does anyone have a diagram that shows what the fuses are for?
  19. E

    Fuse Box location

    how far up in the dash will it be? I've put my hand up in there and don't feel any fuse box. Just the heater ducts. I feel a wiring harness. Maybe I'll follow that and see where it leads. It has to connect to fuses somewhere. :upthumbs
  20. E

    Fuse Box location

    I know this is a completely newbie question, but I am stumped. I cannot find the fuse box in my '74 corvette anywhere. I've noticed the the courtesy lights in the glove box and the dome light when I open the door aren't coming on. I looked under the drivers side dash to the left of the...
Back
Top Bottom