Welcome to the Corvette Forums at the Corvette Action Center!

Search results

  1. Rmodeler

    Value of 86 Vette

    Boys/girls Club of my town is having a fund raiser auction tomorrow. I see they have an 86 Vette on the auction. I don't know anything about the Vette, just saw the picture in the paper. What would be the high/low value of an 86, or would there be to many variables?
  2. Rmodeler

    82 Vette trans. 'jerk'

    I think this has been posted before, but can't seem to find the thread. I have an 82 Vette w/42K miles. When putting the transmission into drive, it jerks, not a 'soft' engagement. Even idling 5-6 hundred rpm, it has this jerk. I'm the 3rd owner, and I'm pretty sure the previous owner did...
  3. Rmodeler

    Power steering problem-82

    It has always steered hard for having power steering. The pump was checked and it was pumping ok. So I decided to change the power steering ram. When we got it out, it was pitted pretty bad. Installed the new one. Now while driving it, when you turn it , it doesn't want to come back to center...
  4. Rmodeler

    Change rear gear ratio-cost

    I have an 82 with std. rear end. I thought about having it changed to a higher gear ratio. Now it is only turning 2K @ 80mph. I know that I would sacrifice gas mileage, but I don't do over the road driving and would like a little more snap driving local. What ratio would be good to use, and if I...
  5. Rmodeler

    82 Fuel gauge

    It never goes below ½. When filled it goes a little ways past the full mark. I replaced the fuel pump(w/85) a while back, and the float seems to be totally free, nothing obstructing it. Is it a faulty/sticking fuel gauge, or are there some other thngs to check out before replacing the gauge...
  6. Rmodeler

    Transmission "jerk"

    82 corvette This may have been discussed before, but couldn't find it. When putting transmission in drive, it jerks, especially if the rpm is up at all. At 5-6 hundred rpm it not quite as bad. It jerks and the back end squats. Shouldn't it go in smooth, without the jerk. I don't notice it...
  7. Rmodeler

    "Leaky" steering wheel on 82

    Left it setting out this last week-wife having a garage sale:mad . Went to get in it yesterday and saw this light brown stuff on my seat and some on the floor mat. It is coming out of the leather at the bottom with the wheels straight. When I bought the car(1½yrs ago), I noticed some around...
  8. Rmodeler

    Engine heat on 82?

    I've by-passed the heater-disconnected the hoses. I still get a lot of heat coming from under the dash. I know that engine heat can be the cause of some of it. I have the heater controls shut off. Is there vent louvers under the dash that could stay open that would let excess heat from the...
  9. Rmodeler

    Horns on '82'

    When they do work, they sound like a sick cow!:chuckle How do you get to them? I can barely feel them, let alone get to them to take them off.
  10. Rmodeler

    85 fuel pump

    Fuel pump complete from "Thepartsladi" in Flordia for $72(GM)-Ebay? Has anyone bought from them?
  11. Rmodeler

    '93' For Sale

    A local dealer has a 93 on his lot-been there for 3-4 months. Its maroon w/blk int., 83K mi., two tops-the glass one shows wear. Drivers power seat doesn't work. Original paint & interior, both in average+. Tires are good. Excellent driver car, but not show. Asking $13900. Anybody interested? He...
  12. Rmodeler

    High start idle

    When I start my 82 cf(cold) it idles at 12-15 hundred rpm. It takes about 5 min.without driving it before it finally idles down to 5-6 hundred rpm. Is this normal? It seems if I take it out and drive it, it seems to take longer before it slows down. I had it out today, and probably drove for...
  13. Rmodeler

    '82' Front end height

    I have 3/4" difference in height from left front to the right front. What height should the front end be? I remember a post on this measurement sometime back , but was unable to locate it. Can the height difference be corrected without changing both springs?
  14. Rmodeler

    '82' T-top storage bags

    I just discovered that the storage bags for my T-tops is about 2-3 " to narrow. I believe they are original leather storage bags with snaps and the Corvette insigna on them. Are they for the older T-tops? Are the original leather ones available for the '82', or do I have to settle for the...
  15. Rmodeler

    RPM's on '82'

    Starting from a stop, it will climb to 3500-3700rpm(auto in 1st or 2nd gear) and stop reving, just like it has a governor? If you put it in neutral, it will rev up like it should. Could this be connected with the transmission not wanting to shift, unless I let up(in another post)?
  16. Rmodeler

    Security system on '82'

    What activates/deactivates the system? Does it disable starting the engine?
  17. Rmodeler

    Can't remove aluminum rear wheels

    Purchased '82' last fall, in process of cleaning things up. Went to remove rear aluminum wheels and they are froze on. Probably haven't been removed for a long time and the aluminum must have corroded to the axle hubs. What is a good way to free them up? Would spraying the area with liquid...
  18. Rmodeler

    Auto trans. problem

    I have an 82 with auto trans. From a start if you stand on it, it will not shift into 2nd unless you let off a little. On slow acceleration it seems to shift into a higher gear and then may shift back down. It just seems to be erractic in shifting. Is this bad news or is this something that can...
  19. Rmodeler

    '82' Engine idol too fast

    '82' Engine idle too fast Is the idle set electronically? Backed the idle screw all the way out but still idles 1000-1200rpm(suppose to be 500-600?). The linkage is back against the stop. I disconnected & blocked vaccum to headlights and it did drop 100rpm. I can't hear any other vaccum leaks...
  20. Rmodeler

    '82' High performance 'chip'

    Just purchased an 82 Vette(1st. one). Along with it was what the previous owner said was a high performance chip that came with the car when he bought it from the original owner. It's in a GM box, about 6-8" sq. and about an 1¼ thick. It has a couple of plugins. I don't see mention of it...
Back
Top Bottom