Welcome to the Corvette Forums at the Corvette Action Center!

Search results

  1. 96corvetteLT4

    Replacement heater core problems

    Those that have replaced their heater core, did you have problems with fitment of the replacement core? I removed mine and went to get a replacement at OReiley, it was not the same. The outlet hoses were the wrong length, the top mount notch was off, etc. After checking several other...
  2. 96corvetteLT4

    315-35/17's rubbing on the rear

    Does anyone else have this problem? I have GY F1 GS D3's in 315-35/17 on A-mold ZR-1 offset on the rear of my '96. I recently installed the tires, replaced well worn Dunlop SP8000. The Dunlops did not rub, but the GY do. On moderate bumps in turns, or on moderate to heavy dips, they will rub...
  3. 96corvetteLT4

    What are the Grand Sport paint codes?

    I need some touch up paint for the blue stripe on my car and do not have the codes. It was painted by the previous owner and is the factory blue for the Grand Sport. I looked in the Tech Center here and could not find the number code to use at the dealer to order the touch up bottles. The...
  4. 96corvetteLT4

    How to disconnect fuel lines?

    I plan on removing my intake manifold and replacing the leaking gaskets this weekend. I have looked it over and it is fairly straight forward project. My one question is, how do I disconnect the fuel lines at the manifold? It looks like it takes a special tool to disconnect the two lines...
  5. 96corvetteLT4

    Rebuilding my Opti-Spark?

    I am planning on replacing the intake manifold gaskets and front timing cover gaskets soon on my LT4. Since the car has 70,xxx miles, I am also planning on replacing the water pump (I don't think it has ever been done). Since I don't have the money to replace the Opti-Spark, I am planning on...
  6. 96corvetteLT4

    Dash Pad Care

    I have a question about dash pad care. The problem I have is that the edge of the pad around the windshield vents in the center is starting to curl upward. Is there a way that I can get it back straight like it should be, or at least stop it from curling further? I have read here about using...
  7. 96corvetteLT4

    No Backup Lights

    I tested with the key on, trans in reverse, engine off. I have checked bulbs, fuse in box on pass side of dash, and transmission connector. I did not unplug the trans connector because it is too diffuclt to reach, but it is fully seated. There are two connectors on the driver's side of the...
  8. 96corvetteLT4

    Water standing around hatch

    When I wash my car, I have water that is not draining away from the hatch area on the driver's side corner, next to the door. There is a small amount in the same area on the pass side. Is there a drain hole on the sides of the hatch that may be plugged up? I have looked around a bit, but have...
  9. 96corvetteLT4

    Remanufactured 6 speed?

    While prowling around under my 'vette the other day, I found a tag on the side of the tranny between the other ones listing the manufacturer, etc. that reads 'Remanufactured for General Motors'. Is this standard, or was the tranny replaced by the dealer sometime in the past?
  10. 96corvetteLT4

    Problems with electronic climate control

    I have a problem with the auto climate control in my '96. It seems to work fine in manual, most of the time. In Auto mode, and some times in manual mode, I can not adjust the temperature warmer. I can adjust it lower, but not up. Also the light above the auto button is dim. Anyone else had...
  11. 96corvetteLT4

    Headliner repair

    I noticed the other day that the headliner is beginning to sag above my head. The passenger side seems to be fine, but I am sure it won't be long before it turns loose also. Is there a 'home' fix for this, or do I need to take it to a shop? If it matters, it is a '96 coupe, black headliner.
  12. 96corvetteLT4

    Door re-alignment

    My driver side door was not lined up properly ( a little low). I adjusted the hinge but now need to move the latch pin in the door jamb up a little. I loosened the pin to move it, but the hole is not elongated. Does anyone know if I remove the pin, will the nut on the back side fall down, or...
  13. 96corvetteLT4

    PKE problems

    New 'vette and questions about PKE. The owners manual says that you can program the remote to operate the drivers door, both doors, or neither. I played with mine and can only get it to work the passenger door. Sitting in the car, if I lock the doors with the power lock switch, then push the...
  14. 96corvetteLT4

    New member, New owner

    I am a new Corvette owner, my first 'vette, a '96 LT4. I have been lurking around for a while, reading posts and searching for information before I bought the car. There is a lot of good information and people here. I looked for about 3 months before buying my car. It is white, beige...
Back
Top Bottom