Search results

I need to replace the plug on the lockup actuator as the three wires pulled out. I have bought the plug but need to know which wires go where? Also it used to lock up but the car has sat and now will not lock the converter up do I need to replace the lockup switch and how hard is it to do...

Looking for part# for anti rattle door window bumper to order from zip corvette cant seem to find on websight . I dont have the catalog . Thanks Ethan oh on a 91 Vette.

I have a 91 Vette. Was running in the drive way then just died and will not start. Has voltage to dist. replaced coil and the little black unit in the dist. No fire out of spark plug wires, anyone ?

I have a 91 Vette w/Lt4 hot cam kit/Big mouth tpi base /ASM runners/ported top w/ASM52 mm throttle body/also w/all cheap free mods. I changed injectors to motorsports 30lbh cut pressure down to 35 .The engine was so rich it would not run . I bought a Ed Wright chip this helped at least it runs...

Need new opti for 94 Caprice has the vent hose on it so I quess it is the later 95 model? Any one know the cheapest place to get one.

Anyone have a oil leak on there 91? Has anyone heard of a head gasket leaking or blowing out on the driver side back where the oil drain back hole is?Or anyone had the oil galley plug under the driver side head leak. Already replaced intake gasket,valve cover gaskets,both oil sending units also...

Going to change ratio from 2.59 to 3.54 in the dana36 or more cost effective to buy a used dana 44 out of a six speed car with 3.45,s any comments welcome ,cost on a used dana44 verses ring and pinion plus labor on the 36.

What is the baseline fuel pressure setting on a 91 TPI and a 92 up LT1. My book on the 91 said 35 but i think this is to low maybe 40 to 43 .

My vette has the worst gear the factory has to offer 2.59. What are my options buy a used dana 44 with 3.45s or I've heard you can squeeze 3.54s in a dana 36 case. Anyone done this to a dana 36?

Does anyone have a diagram showing what color wires go to which pin on the lockup converter plug. When the car is not running I can manualy turn the vss out of the tranny and get a speed reading but running and going down the road no reading.Im thinking maybe the wires are crossed somehow in...

Need help just replaced vss sensor and gears in tranny look good .What else could be wrong on a 91 Vette with Lcd spedo display.Always reads 0 no indication of speed is this connected to the lockup converter plug also? Thanks Ethan

Question need to find out if tranny is original to car. A 1991 Vette looks to have been rebuilt casting#8663551 on tranny 8654732 on front pump service tag #1yhm2 serial #on tag 2127 65309 and stamped into tranny on driver side back 21 1829 0989 and 1k5124390 this last one I hope is not serial...

Just fired up engine with new Lt4 hot cam was setting timing and engine just seemed to be getting richer and richer untill it died.Ran great at first then just started loading up and would not clear out.The car has adj. regulator and kind of ran rich stock without mods. I know I need to check...