I am not trying to sell these in this post, I'm only looking for the name of these items. I have these two "things" that made to fit over the front wheels wheel well space and provide a workbench like space for the C4. They are made of a rugged plastic and really did a great job holding tools...
Last Saturday I'm driving my '08 A6 F55,w/31,000 miles and after 3 or so miles and 4-5 stoplights,I get a check engine light.My transmission is also not shifting.I shift into S and paddle shift.It doesn't respond to that either.
I go to my next left tun lane,come to a complete stop,wait a few...
Anybody had to do a brake job on their C6 yet?I have almost 25,000 miles on my 08 F55 and am expecting to hear the brakes start squealing any day now.I'm wondering what the avereage or expected lifespan of the stock pads may be.
I was wondering.In the console of 2008 coupe,I have a 12 volt accessory socket.There are also two dummy plugs with a cover over each.Behind the covers are phillps screws.Is it possible to install two more power sockets in those spaces?If so,where would I get them?
People are gonna think I'm crazy.I traded my 2005 coupe for a showroom floor 2008.Fully loaded.Both tops.Navigation.Everything.Now here's the crazy part.
I hate it.
I bought my 2005 used off the lot back in September.Love at first drive.The power band was perfect,the shift points were right...
Was the FX3 suspension an option on the 1990 ZR1?I thought ALL ZR1 Vettes came standard with the FX3 suspension.
I ask because I called about a ZR1 for sale about 250 miles from me with low mileage on a car lot.I asked the fella to go out and look for a knob on the console in between the power...
Does anyone have an active Carfax subscription right now?
I located a 96 LT-1 with 73,000 miles for $14,000.
It "looks"good,but it's a "bare bones" model.Coupe BTW.
We've got a 93 LT 1 that had run great for a long time.Recently,somebody siphoned the gas out of it and that's when my problems started.
When we got in the car after this it ran fine,I drove a couple of streets over from my house and stayed at a friends for a while and when I came out it...
The lights are on again.They won't shut off.
Last time this happened I was able to shut them off by cycling the circuit through the CCM.That trick isn't working this time.
I'll have to perform the full diagnostic this time I suppose.I really don't like removing the seats,console,trim plates...
I was having a problem with my 90 FX-3 C-4 handling a little odd i.e. rear end swinging out to the right on medium accelleration from a dead stop or a hard downshift(automatic trans),so I swapped out the wheels and tires with the original set I had stored in the garage.The handling problem went...
In my 1990 service manual,section 8A electrical diagnosis supplement,one of the first steps for diagnosis for interior lights remaining on is to check for a defective door key switch.The note refers to Chart #3 on page 8A-133-6.
Page 133-6 is blank in my manual.It's not intentional like most...
I am replacing the starter on my '90 L-98.:bashThe GM service manual refers to two shims which go beween the block and the starter.When I pulled the old starter off,I didn't see any shims or hear them fall.They aren't stuck to the block or the starter.Maybe they weren't there?Absolutely...
I have replaced the torn boots on my upper ball joints on my '90.
The factory manual says to torque the four upper ball stud mounting nuts to 19 ft.lbs.
Uh-uh.SNAP.SNAP.SNAP.:bang
I've already twisted three off.I'm using 1/4 inch grade 8 bolts.
My dealer doesn't sell the replacements...
What the frig is up with GM discontinuing so many parts for my Vette?I thought that they had to make parts for 10 years after production ceased,but we're having problems getting parts for 1995 models.
I personally have a '90 that I can't get new parts for,but my buddies '95 has discontinued...
First off,Mobil One oil filters are THE BEST.I learned that here!
:CAC
Anyfoo,I was greasing the ball joints and noticed all the rubber that holds the grease in was busted.:cry
According to my service manual the ball joints are still good ie.the zerk has not slipped down into the housing.If...
I was "slumming" and found this.Is this safe and/or workable?
This modification was performed on an 87 Vette with approx. 100K on the odometer, a gutted MAF, a K & N air filter, Jacobs 8.5mm plugs wires and Delco sparks that are 2 heat ranges hotter than stock.
I tried this modification and...
Will some of the trim,specifically the doorsill trim on the rear of the door,interchange in these models?
Also,what is the trim panel to the right of the accelerator pedal called?Mine has broken,but I don't know what to ask for.:duh
I am having a little problem keeping my T.V. cable in the idea setting.I adjust it,and get great response.Until I floor it.Then it won't shift soon enough.It reverts back to a position better reserved for a moped.No reasonable response on full throttle.I have to get out and readjust it.
Did I...
As you may know,I have just gotten my Vette back on the road.
I can't seem to remember if my SRC was backlit or not.
It seems that it would be,since the seat controls on either side of the SRC switch have backlights.
Anybody know?:confused
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.