I have a 72, S/B, non posi (67 carrier), 3.36 differential taken apart for sale $225 all in very good condition will sell parts. Also stub shafts $25 each obo, good condition no play, rear end cover $50 good condition one broken bolt. Send E-mail to tentuna@optonline.net
F/S Various C2 Parts
Differential Housing, N/R, 72, (numbers are for a 3.36 posi), ready for sandblasting $50
Differential cover, restored, 72, $50
Yokes, half shafts, set $25, sold
Pinion yoke, $25, sold
Open carrier 66, $10
1972, 3.36 gears, no wear pattern $25, sold
Strut rods, fair (need...
Can I use a 1971 Corvette rear in a 66 Corvette. My rear is shot but Ican purchase a complete 71 rear to replace internals, are they the same, if not what is differences, posi, ring & pinion, etc.
Thanks
No luck pulling stud out, threads strip and the stud does not move, will start tear down today. Pulling head for machine shop to mill out and install thread in.
While I am at it, I was thinking of replacing sender since restoration it's been action up. Can anyone comment on the accuracy of...
Does anyone know if the rocker studs in a standard 461 heads are screwed in or pressed, I broke #4 exhaust and need to replace it. Can not see any reason except for fatigue for the failure.
Charlief
66 Coupe
I have a question, I replaced my heater switch and now have a high speed fan and missing the two slow speeds. I checked the dropping resistor and it seems there is no voltage on the common, any ideas?
Thanks,
charlief
66 Coupe
I have some of the shields for my 66 small block, but need some parts to complete. E-mail me at tentuna@optonline.net if you can offer.
Charlief
66 Coupe
Need LH heat spark plug heat shields and some shield pieces for 66 SB application. Don't know exactly what I'm missing, I have the large shield that covers the distributor and two L shaped legs (I assume they go on the block), all else is gone.
Thanks,
charlief
66 Coupe
I am pulling a temporary 350 and replacing it with the original 327/350 that came with the car and need some advice. I would like to leave the tranny and bell housing in the car, do I have to drop the steering linkage (car has P/S) to allow for the input shaft into the pressure plate and pilot...
Engine Giveaway
Ifanyone is interested in an early 70's 350 short block from an Impala I have one, will give it to anyone that wants to pick it up.
E-mail me with requests tentuna@optonline.net
Thanks,
Charlie
66 Coupe
Hockey sticks, average, yes there is light pitting
Wiper grills, chrome, excellent condition
Gas door, some crazing, with SS ring
Alternator, not correct date but 55A
Starter, S/B, do not know vintage, working
Hurst/GM Shifter and rods Chevelle 60's vintage
Copper Brass Corvette radiator, no...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.