Hello,
Driver Information Center Low Oil light stays always on. Please help to resolve that issue. Will appreciate for FSM schematics, helpful link, etc. advices. Thanks.
Just different stepper motor is...
Thanks Guys,
answering boomdriver's question - yes, it's different stepper motor now installed, - it has different wire harness - so I am puzzled which wires now do what: with motor feed wires its clear which are those, question is which is +5 Volts reference...
Hi Everyone,
Installed 1993 airconditioner air mix door actuator into 1990 (car is with RPO C68 - Electronic A/C), now a/c cannot calibrate itself, actuator is permanently in move - rotating forward and back all the time, - seems there's difference in 1993 vs 1990 actuator harnesses, but I don't...
Thanks everybody who participated!
It was so simple!!! To remove lever without diassembling steering column - one has to just PULL IT OUT!!!! To attach - just PUSH IT BACK to it's place!!!! Now I know it after seven sweats are gone )))
Thanks again people!
Check Hatch release solenoid and/or latch assy
Remove the central plastic trim of trunk area to get access to trunk latch. On latch assy unplug solenoid connector - check connector for voltage to ground with test light while pressing each release buttons, if voltage ok - then solenoid is...
Found those fantastic digits:Twist
The ones on the right rail digits are kind a manufacture date,
And those on a driver side rail under the battery are last 8 digits of VIN:dance
c4cruiser, Wegone, thank you guys for your help:beer :CAC
Hi,
painted my C4 from stock black to red. Today was at police station to re-register the car. Verified VINs: under windshield driver side, tranny VIN, engine VIN. The label on door edge was removed while painting - so officer started to search for another "body-located" VIN. FAILED. And so did...
What I'm going to do is install one more steering fluid cooler to tranny cooling lines. Of course would wash out old PS fluid with transmission fluid before installation. Would install in front of existing steering fluid cooler - 1.5-2.5 inches apart of it. Would post later on how that works...
Hi everybody,
what is that electrical connector which comes to Brake master cylinder?
And where goes the other end of that wire to?? :confused
C4 1990 L98 Auto Coupe :BOW
Hi,
please advise on which modern fluids are recommended for replacing specified fluids below, Mobile and/or Castrol brands preferrable:
VETTE 1990 BASE:
- ENGINE OIL:
GM Goodwrench or equivalent for API SERVICE SG 5W-30 ENERGY CONCERVING II - replace with??
- REAR AXLE OIL:
Lubricant SAE...
Privet Hrtbeat1,
Yea it will be complete stock, except for exhuast - long tubes with emissions, and air filter will be open K/N.
Sometimes It gets so deep intimate that I'm afraid to use the fuel filler neck one day :D
Privet (means Hi) Hrtbeat1. No doubts we are we are a community of UNIVERSAL scale:beer
My beauty becomes cooler and cooler day by day since I'm working hard on it's complete rebuilt. Once it fininshed - I put fotos immideately. Here in Moscow we have just 20 (or close) C4s... It's a very...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.