Search results

We have 1987 corvette 52,000 miles, and last year we changed the right front caliper because the boot was tourn and the caliper was locked closed. Since then the car pulls to the left, and we still have a locked caliper on the right front, I have changed to hose bleed and tried to bleed the...

Looks like I found a bad code for my 87 with climate control. The light was blinking I found the procedure on this site. The out side air temp sensor was bad. I replaced the unit, disconnected the battery to reset the codes. Its know showing 00 no codes but outside temp shows any were from 129f...

Does anyone have the procedure to extract the diag. codes for the climate control. The external temp is flashing when I start the car. It show -39 and -38 in the external temp when driven. I know the car needs a charge so I will have that done today. I just replace the ATC power control module...

I have an 87 vette and the headliner is coming down. I want to put a new one in but I have a question how do you remove the cardboard. I have read some post the just pop it out how? Does the trim around it have to come off? Thanks

What is the procedure to aim your headlites; Everything was take apart when I had the car painted. I know were the screws are but there has to be a procedure to adjust them correctly. Anybody have any experience with this? Thanks

I have been working on my cousin's 87 vette with climate control; The fan never blows out on high even though you set it on 10. Is there a high fan relay for this car and where is it. GM cars used to have a inline fuse under the hood for the high fan speed. My 85 with the old manual ac switch...

My friend has a 64 with 327/300 powerglide all stock inlcuding afb carb. We can't get the tranny to kick down. We adjusted the kickdown linkage in two turns(no change) then we adjusted out 4 turns still no change. Anybody have any suggestions. Thanks.

I do not have any information lables on my car and was wondering if anyone out there has an 85/auto/Z51. I need to know what the timing should be set at. Does anyone know where to buy those information labels. Thanks

My buddy at work just email me this item: This car sounds better each day: Corvette. Details are emerging about the all-new, 2005 C6 (sixth generation) Corvette that will be introduced at the 2004 North American International Auto Show in Detroit in January. Though the new...

someone at work just gave me this link looks pretty good! http://autoweek.com/cat_content.mv?port_code=autoweek&cat_code=carnews&loc_code=index&content_code=09200909

My 85 (115,000 miles) has just started to give me a problem where she stalls out when hot over 200 degrees. She will not startup until it cools down. No check engine lite. I started by changing the ingition module, coil and cap. The fuel pump was changed about 1 1/2 years ago. After installing...

Does anyone out there know how to remove the center door mouldings on a c4. I getting ready paint the car and i want to remove them. I can see two(2) nuts one at the front the other at the back of the door. I removed the door panel but if there are nuts holding on the rest of the moulding it...

Hello everyone. Just notice that the bushing's on the trailing arms are worn out. Was thinking of just replacing the bushings. Does anyone out there now if you need a speical press to replace them? Looks like there are four trailing arms in the rear.

After spending the winter fixing up the 85, I am a point now that I want the car repainted. I have a couple of questions for any who has some experience with this. 1) Should the car be sanded down. 2) What about media blasting 3) Is a chemical strip the way to go. The car has been repainted...

My 85 vette will sometimes blow out smoke from the exhaust after driving the car around, then stoping for a while and then when you restart you get a cloud of smoke, looks blue/white. The car will not do this when you start it up in the morning. Only after you have driven around for a while...

Has anyone changed rear wheel bearings on a C4. Is a puller required to get the bearings off the?

Great site, I already received great help. Having a problem with my p/s. When I first got the car the p/s would cut out hot or cold. I replaced the belt tensioner, and belt. Now I have p/s when cold. When I drive the car around for a short distance, and when I come to a light if you try to make...

I removed a wood trim kit on my 85 vette. Looks like whoever installed the kit removed what looks like an air bag on the passenger side of the dash. Not a problem called comtemporay corvette received a good but used part. Now here is the problem I see four(4) places where this thing bolts into...

1985 Corvette. Just replaced the blubs in my dash. Dash still will not lite up, blinkers lit, as well as high beam. Everything works on the dash except the lites. Does anyone have an idea whats wrong?

Having a problem with my 69 convertible, changed front springs, ride hight even, changed rear spring, shock mounts, bushings bolts etc. The rear is higher on the passenger side by about an inch. I also changed the drive side trailing arm because i could not get the car aligned. Turns out the...