New clutch master,new slave,bled correctly,push down clutch peddle and slave pushs back fork,can't slect any gears?
engine off i can slect all 4 gears and reverse.
Push in clutch,slect gear,start engine,gear will work,pull out of gear while engine running can't slect any gear.
Singros?
Throw out...
Can't figure this one, drive car normal,shift normal,turn off,let sit couple hrs. Put in clutch,start,shift out of reverse,can't shift into 1st, will go in to 3rd,and 4th,will finally work into 2nd,then 1st. After driving couple seconds shifts normally? If i let car sit couple days,or just over...
All dash funtions work great, except the speed digital read out is not as bright as the tach readout? Could it be just the bulb? and is it a replaceable process, with out removing the cluster?
I just replaced my headlite motor bushings, works great. thanks to the forum for the nessary information to complete the job. Question, someone else had done the job befor me and did not reinstall the wire clip for the locking knob It is missing. Is this a nessary part? and will i have future...
Pulled cover off for spring, sat in vette, depressed clutch to start, peddle droped to floor with a bad feel. started car and clutch catches just off the floor. so bleed first, or replace master? any special info,except the 45 degree on the slave when bleeding the system. i just replaced this...
cruise stoped working, have no power to module when i turn to on , on the slector arm. i get power to the break peddle switch? and the fuse is ok, but nothing to the 5 wires at the module?
after messing aroung the power to the break switch stoped to? the problem seems to be in the steering arm...
clutch grabs right off floor. pulled off master cyl cap almost mt. refilled, bleed slave cyl. same problem. should i replace both master and slave cyl. where should i start??? ofcourse very hard to shift, and i'am not forceing it into gear
clutch has on play, grabs right off floor. took cap off master cyl. almost m.t.. refilled , bleeded slave cyl. still the same. should i replace both master and slave cyl., or start at which one first? please help!!!
I cleaned out my raditor front,and replaced all hoses,thermostat ect: Put new therm. gasket and torqued down,but inlet leakes. when i removed old gasket there was no sealer on it. Should i use some now?
LOST WHEEL CENTER CAP!!!!!
help!!!!!!!
Lost center cap to my BBS rim. Can anyone please let me know where i can find a new or used replacement. Can't drive with my hub nuts showing!!!!
HELP!!!!!!
LOST THE CENTER CAP TO ONE OF MY BBS RIMS, CAN ANYONE PLEASE LET ME KNOW, WHERE I CAN FIND A NEW ONE??????? I HAVE EXTRA CENTER DECALS.THESE RIMS, I BELIEVE, HAVE BEEN DISCOUNTINUED.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.