on outlet side of pump of 427 brass fitting was loose took off and mangled looking o ring was in there put back with teflon tape got it tight to line up for line to carb now have leak at pump should there be an o ring in there or use something other than tef tape thanks John
when I pulled Carb off gaskets where wet so I dont think end of throttleshaft is prob now I have gasket on manifold ss baffle then carb still have leak maybe bad base on new carb ???? thanks John
checked carb this morning still leaked after sitting over night same spot pass side at throttle plate area under secondary diaphram carb is new dont know whats causing this p.i.t.a thanks for help John
I had that set up too gaskets leaked plus I thinkI had a vac leak I just did what John said put gasket down first then ss baffle plate then carb ran car will check for leaks after I also blocked the two holes in heat passage JOhn
Ihave new 3370 holley installed and I get leak at base pas side what is the right set up for gaskets for 390hp sloted gasket is first then thin alum spacer then gasket and carb I get leak after it sits over night not when running thanks John
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.