Welcome to the Corvette Forums at the Corvette Action Center!

Search results

  1. A

    92 Coupe floorboard repair

    Hi Does anyone know what is used to seal (bond) the fiberglass portion of the floor board to the aluminum portion directly under the driver seat? It appears to be some type of epoxy and most of it has broken up. What can I use to replace it? I assume I need to remove all of it that I can see...
  2. A

    Help! 1992 C4 running much hotter than normal

    Hi The needle on the temp gauge on my 1994 C4 usually sits 1/2 - 3/4. Yesterday it started going all the way up to the 230-260* mark on the gauge. While driving it back home I jumped terminal "A" & "B" on the port under the dash and the fans turned on (left them on while driving) but the car...
  3. A

    92 C4 Coupe Has No Heat

    Hi everyone I recently started driving my 1992 C4 coupe everyday and have no heat coming from the vents. What things would you check first? Sent from my iPhone using Tapatalk
  4. A

    1992 Service ASR / Security Blinks 3x / SYS flashes at speedo

    Hi I have a 1992 coupe with 155,000 miles on it. The "Service ASR" light just came on along with the "Security" light blinking three times and "SYS" blinking on the speedometer display. The car continues to run but once I turn it off it will not start again. If I disconnect the negative battery...
  5. A

    Brake pedal hard after car wouldn't start

    Hi My 1992 C4 has a new issue. I drove the car two days ago and it ran great. This afternoon I went to start it and the motor just cranked over but would not start. I tried for about 10 minutes and when I released the key I occasionally could hear a misfire. I let it sit for about two hours and...
  6. A

    C4 sputters in OD under load

    Any recommendations on where to get a replacement for the optispartk? This only ever happens under a load while in 4th gear in the overdrive position. Never does it in Drive Sent from my iPhone using Tapatalk
  7. A

    C4 sputters in OD under load

    Hi I have a 1992 C4 coupe automatic and it starts and runs perfectly fine in drive. When I have the car shifted into overdrive which is how I've always driven it the car is fine until it's in 4th gear. Once in 4th and you start to put a "slight" load on it like a gradual incline or if I lift my...
  8. A

    Brake pedal hard & hissing

    Brake booster replaced and back on the road. The pedal doesn't engage as high as I'd like it to but we have brakes again! Thank you!!!
  9. A

    Brake pedal hard & hissing

    Thank you!
  10. A

    Brake pedal hard & hissing

    Any suggestions on where to get or what manufacturer on the brake booster?
  11. A

    Brake pedal hard & hissing

    Hi everyone, I have a 1992 coupe and over the past week noticed the brake pedal at times extremely hard to press down and feeling like the car isn't going to stop. Yesterday I noticed for the first time that if I have the brake pedal pressed down I can hear a fairly loud hissing inside the car...
  12. A

    front licence plate cover ?

    Two Phillips head screws on the bottom
  13. A

    2014 C7 Corvette Stingray Unveiled!

    Absolutely love it.
  14. A

    Will a seatbelt from a '95/96 coupe fit a 1992?

    Hi I've been searching for a new replacement driver side seat belt assembly for my 1992 coupe in beige. I just found a new one in beige for a '95/95 coupe. Am I correct that this should fit a 1992? From the picture of them it looks like the cover at the top of the pillar is black and mine are...
  15. A

    Help! Oil substance in '65 body

    I did a quick Google search for the product and it looks like there are a few places that have stock left over for sale. Good luck
  16. A

    Need help with broken piece in steering column

    Thanks LLC5 & Vetteoz! I'm ordering it now just incase this one breaks again. Thanks again for all the help
  17. A

    Need help with broken piece in steering column

    Thanks Vettoz.. Mine doesn't look like that but it could be. Have a great day and thanks again.
  18. A

    Need help with broken piece in steering column

    Thanks! It was actually the plastic sleeve located in the steering column that the wire in that picture slides into and locks in place. I was able to use some epoxy and then JB Weld to repair the piece and everything is all back together and working. Thanks for the help
  19. A

    Need help with broken piece in steering column

    Hi, I pulled my steering wheel tonight to replace it with a restored one and found that the sleeve (located on the steering column) that the contact wire for the horn goes to is broken. The sleeve has a channel in it that the horn wire pushes into and then the wire hooks in place under some...
  20. A

    Ecklers or Corvette Central for steering wheel restoration?

    Thanks... I was able to easily get the air bag off and pull the wheel but ran into another issue... My horn always seemed like something was not right. Well when I pulled the air bag off a small piece of plastic (size of a nail clipping) fell out. Turns out it is a piece of the plastic sleeve...
Back
Top Bottom