Thanks for your reply have you put them back on car yet I need a picture of a car with post installed since I am having trouble with gap at bottom windshied/top of post, Michael
hello, can someone tell me if my door post should be a bit wavy or did my plater mess them up I noticed some of the chrome has a few ways such as the bumpers but don't know about post thanks, Mike:confused
I had the same problem with my 60, it was draining my battery when switch was off,I don't have all the tech details but I remember there were 2 red wires on back of switch that were reversed I think everything worked which made me believe it was hooked up right but it ended up thats were the...
I have a brand new reproduction hood for a 1960 vette it has not been on car I found out after I bought it I could have my damaged hood repaired. $475.00 buyer to pay shipping cost from northern,va p.s. I think I paid $650.00 a few yrs back ,mike
tom, I am zeroing in on problem the bottom gap is pretty good I have checked all shims they are pretty equal except the rear if I raise the rear of body up it does not seem to be in to much strain and it closes door gap to about 1/4 inch all around which I think is ok the only concern I have...
I have painted and put back together my 60 vette and now realize I need to re-shim my car for doors to fit properly:confused does anyone have any tips to make it any easier. I am thinking I need to have it on the ground with proper size tires or can it be done on jack stands any ideas will be...
;helphello, I am pre -fitting door post and windshield before painting my 1960, windshield fits body perfect, but there is a 1/4 inch gap between the 2 post when I bolt up door post, are there any tricks to moving door post forward thanks michael
;helphello,I am restoring a 1960 vette that someone else took apart and I have not been around any vettes to look at to see if I am doing thing's right. (That said) I put the door glass and regulator in and when I rolled it up and down it (glass) tilts to the back and the front of glass dosen't...
hello, I am new member working on 1960 corvette horizon blue 230 h.p. 4 speed I took apart 25 yrs ago. I am installing new w/s with repro lower channel I have been on ncrs site getting some help, I quess alot of you are members ncrs. however my question is how does lower stainless moulding...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.