Well I finished my cooling system rebuild for the most part. I forgot to order new tubes for the trans. Cooling lines and I apparently lost my upper support bracket cushions so those will have to wait a couple weeks. I got new hoses, water pump, fan, clutch, pulleys, radiator, reservoir...
Hey everyone, I bought a new intake manifold awhile back and I'm starting to buy new sensors for my car. Well I have two holes in the front of the manifold so my question is, what goes in those holes? Do I simply plug them or do sensors go there?
Happy new years everyone! I'm pleased to say that I've learned an invaluable amount of info and history on my c3 because of you all. Hope everyone got home safe. So what did you guys n gals end up doing this year? I decided to keep it mellow this year and spend it with my family at home.
Hey everyone. I was wondering how difficult it was to install a fuel injection motor and setup out of a C5. Is it essentially just the ecm, wiring harness, and drive shaft?
I finished the intake manifold install today so while I'm waiting for my other parts to arrive, I removed the old water pump in preparation for the new one and cleaned up the cooling fan. I pretty much just used what was laying around in the garage and it actually turned into a fun project. I...
Hey everyone, just looking for some feedback from people who have installed a new engine harness. How easy was the swap and did the harness come with the appropriate wiring for the carb and choke.
Thanks for any input,
White
Hey guys, I read somewhere that the L81 motors were deadvanced at the factory for emission purposes and advancing the motor by 10 degrees would help restore some lost power. is this true? Also will I fail emissions if I do this?
Hey everyone, I bought a fuel pump from zip and I'm having trouble connecting the carb line. The square port is facing towards the drivers side door, it seems like it should be pointing towards the drivers side headlight in order to work. I saw on their website that they sell a 90 degree...
Hey guys, is the front deff. Yoke smaller than the sides? I just finished my rear end rebuild last night and went to install my drive shaft when I found out the u joint straps I used for the half shafts were a quarter inch to long. Thanks
Hey guys, I'm trying to replace my ignition switch and I'm having a hard time figuring out how to remove the old one. I tried checking my assembly manual but I can't find it anywhere. Any tips?
Hey guys and gals, I'm flying out to Mass in two weeks to finish my rear-end rebuild and finally ship the car out here to sunny california. My question is, which parts need to be re-assembled in the air and which parts need the cars weight? I would check the assembly manual except i had that...
Just wondering, if an original alarm system wasn't hooked up or if there's a short somewhere in the wiring, will it prevent the car from starting? or is that too advance for these cars?
Hey everyone, its been over a year since ive been on here so i'd like to cordially say howdy and how i missed you all ever so much and all your wealth of knowledge :beer, cheers. Well I'll get to my first question already haha. The P.O. had a basic fuel setup with a Holly carb and i'm trying the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.