The base stereo system in the C6 is disappointing to say the least. Today I installed JBL GTO rear and upper door speakers. The woofers remain stock. The re sult was very pleasing. The biggest problem was finding a wiring diagram. Here it is if anybody needs it.
Today I installed a HUD in my 09. It was purchased from PartsTaxi.com and came with everything necessary for a complete installation. This involved unbolting the dash and sliding it back enough to shoehorn the display unit into place. If I had it to do over I would remove the dash from the...
Blue 6 speed manual trans, Borla exhaust, 83000 miles Very good condition Newer tires, new weatherstripping,
Call Tom (586)242-8124 Macomb, Michigan $8600
SOLD!
92 LT1 I have been noticing a coolant smell the last couple of days. Today I popped the hood and the serpentine belt is wet with coolant. There is no noticeable leak anywhere. Probably the water pump.:( Any thoughts?
Using my new scan tool the ac pressure (line 02) is at 69 lbs with the air off. Is this normal? Can't find this in the FSM. Probably is in there but I have spent a great deal of time searching with no luck. The system was recharged with r134 at some point before I owned the car. Pressure is...
Been chasing this for weeks now... 1992 LT1 6 speed idles at 850 when warm, 1200 when cold or before coming to a complete stop. Has both cats gutted Borla exhaust, K&N air filter with the housing opened up on each side. Could these mods be causing the high idle? Been through the throttle body...
Today I removed my throttle body and cleaned it. Idles much smoother now. It still seem to idle too high to me, about 850 rpm's. Also when stopping it idles at about 1200 rpm's until coming to a complete stop. Stick shift. Is this normal?
Today I decided to clean my throttle body and re-calibrate the TPS and IAC. Started with the FSM for info and lo and behold it only shows a Vin "J" TB and mine is a Vin"P". They are totally different. Can't find any detailed posts describing how to make these adjustments...;help
I am thinking about removing my smog pump and installing long tube headers om my 92 LT1. Has anyone done this? What do I need to know? Will removing the smog pump cause ECM issues? Any info will be appreciated.
;help1992 lt1 6 speed. When I run the air conditioning my belt squeaks. I have replaced the belt and idler pulley. If I rev it up a couple of times it stops. Air blows ice cold. Any ideas?
On my 1992 LT1 the brake pedal is hard to depress before starting. The vacuum is obviously leaking down as the car sits. My question is, Is there a check valve that could be going bad or do I have to replace the whole brake booster? Thanks, Tom
What kind of computer do I need to re-program my ECM? I want to purchase a hypertech chip and adjust some things like cooling fan temp and speed limiter. Any info would be appreciated. Thanks
:coolJust for anybody that is expierencing this same rough idle problem. Once the car warmed up it idled rough and knocked. Very embarrasing sitting at a traffic light. The knock sounded like it was coming from a loose heat shield on the cat. I pulled the cats off and the passenger side was...
;shrugHI, I am trying to fix the problem causing my service asr light to illuminate. It seems that my ccm and ecu are not talking to each other. Also my sys light flashes. This causes the ecu to shut down the fuel flow. Ok the FSM on page 8D-15 at the top of the page shows a terminal "S222"...
;helpHello, I am new to this forum and a first time vette owner. I have a problem with my 1992 ls 1. As I drive the asr light comes on, then the security light flashes and the gas mileage info goes boffo. The problem is not the ignition switch as I have bypassed the key chip with a resistor. I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.