Welcome to the Corvette Forums at the Corvette Action Center!

Search results

  1. K

    Transmission Detent cable broken at connector... Repair possible?

    Another thing I'll have to address with my new to me '87 is that the plastic end piece that hooks to the throttle assembly is broken. The piece is there but the part that hooks on is gone. Is there any way these can be repaired to keep in use or does the entire cable have to be swapped out...
  2. K

    Rear intake duct availability..

    I called my local GM dealer and was told that these were discontinued. Why, who knows. I am having no luck locating one locally and may have to wait a week or so before I get get one. I am looking at these...
  3. K

    Vacuum lines to no where.. What do they connect to?

    Among the cut wires and hoses not being where they were supposed to be, I have come across three, I believe vacuum tubes that I can't figure out where they go. The first one goes to the canister area in the front driver side corner and has this on the end. It reaches near the rear of the...
  4. K

    I know Service part ID's Z51 and Z52 but...

    What is this Z31 on my '87's build sheet? Is that the stock suspension ID#? I can't find it listed anywhere.
  5. K

    Where is the Left side actuator relay?

    I have found the three of them and isolated the driver side relay. What I'm doing: Doing some electrical tracing on my '87 Vette and I'm trying to figure out why the driver side headlight pod isn't getting power. The headlight goes on, but the bucket won't move. I checked for power at the...
  6. K

    After 14 years, my "New to me" Vette started... Guess I should carry on?

    First post here, well second if you count my Intro. the other day. I picked up an '87 Convertible last Friday, 220,000 KM that had been sitting tucked away in a warehouse for 14 years, as a winter project. After doing a lot of reading here I am getting a somewhat basic idea of how these...
  7. K

    40 years of dreaming and procrastinating.. I finally got a Vette..

    Good evening all, I finally got a Corvette last Friday and although it isn't the '63 Split window coupe that I've dreampt about, it will be a good starting point for me. A buddy of mine knew I was looking for a "Project" Vette to keep me busy for the winter and put me in touch with a pal of his...
Back
Top Bottom