Welcome to the Corvette Forums at the Corvette Action Center!

Search results

  1. H

    Help! 1996 C4 after rebuild won't idle and stalls when put in gear

    I have ordered a tune from Solomon but the engine is misfiring and coughing through the intake. I contacted Cooper Corvette and they said they would replace the Optispark because my symptoms were consistent with a bad optical. I'm waiting on the new part.
  2. H

    Yet another running hot question

    I have a 96 and the gauge is like an idiot light as another poster stated. My gauge is fed directly from a sensor on the passenger side block. The ECM/PCM uses another sensor that is on the face of water pump. But I also have an oil temp gauge that syncs up with coolant temp gauge when engine...
  3. H

    Help! Over heating

    Good tip! I'll check into it. I recently replaced thermostat and shopped all over town for a 160 and couldn't find one. I would definitely like to have the old gurl running cooler.
  4. H

    Help! Over heating

    I would be looking at heater hoses based on your description but my 96 also hast the tank fill reservoir in that area. In my 96 I have an oil temp and water temp gauge and they should sync up after the engine warms up. My water temp gauge runs off a sensor on the block but another sensor on...
  5. H

    Help! fuel problems

    I'm not an expert but you should have some pressure. When you go through removal procedures for injectors & fuel regulator it tells you to relieve pressure in tank by loosening cap. I'm not aware of a vent but interestingly enough, if you let that water drain tube get blocked, water will get...
  6. H

    Help! 1996 C4 after rebuild won't idle and stalls when put in gear

    I'm not a mechanic but my father ran a shop that I helped in when I was a kid. This is first major thing I've done in 40 years since. 1996 C4: after rebuild won't idle and stalls when put in gear. (automatic) No errors in OBDII: It's now a 383 w/Lunati cam: Duration 250/256, Lift...
Back
Top Bottom