Welcome to the Corvette Forums at the Corvette Action Center!

Search results

  1. JonJon

    Question: 1986 Clutch Start Switch

    Hey Group I just replaced the clutch slave cylinder/master cylinder combo on my '86 coupe. The clutch pedal always had to be all the way on the floor for the engine to crank but since master cylinder replacement, the engine won't crank unless the clutch start switch is jumped. The FSM page...
  2. JonJon

    Question: 1986 Clutch Start Switch

    Hey Group I lust replaced the clutch master cylinder/slave cylinder combo on my '86 coupe. The clutch pedal always had to be on the floor for the car to crank and since the master cylinder replacement the car won't crank unless I jump the clutch start switch connector. The FSM on page 8-B-15...
  3. JonJon

    L98 Code 13

    Hey Gang '86 Coupe L98/DN 4+3 The car sets an intermittent code 13 and trips the SES light. It only happens at cruise/light throttle at highway speeds and takes 8-10minutes to set. Fuel pressure/volume are verified and base timing/min airflow are properly adjusted. Wiring/Vacuum lines have...
  4. JonJon

    Connector Questions

    Hey Gang I need a couple extra sets of eyes. '86 coupe L98 TPI w/ manual trans, 10/1985 production date and iron heads. Where is the bullet connector I need to disconnect to set the base ignition timing? The FSM shows C106 in the wiring diagram and I can't find it in the connector location...
Back
Top Bottom