Search results

sent you an email & PM re: a hood Jim

Need to section in a piece of the rear deck & hoping someone is parting out a car or has some scrap pieces laying around. Need about a 10" x 10" piece of the left rear corner. Can be from either a coupe or convertible. Thanks Jim

No problem, I was planning to do the final fitting of the nose on mine Saturday. Sunday my daughter has a soccer game at 10. That leaves a few hours Sunday afternoon before the football games start Jim

First make sure all of the bolts are loose. Everything bolted up before, right? Yes, the protrusion in the disk should be inside the hole on the bracket. There are two locating/guide holes under the door sill plugs. Use a drift or screw driver in each hole too move the body around to get the...

can you email a picture & price for these 16. Pair of rear 1/4 trim pieces with seat belt retractor covers. Thanks Jim jim.n.deb@verizon.net

I have the rod that installs vertically at the rear of the door & the bell crank. If you still need them that is :) Jim

No problem - the one I have is 29.5 " center to center of the u-joints, 2.5 " diameter.

I have an automatic driveshaft, but I believe it is for up to 79. Do you know the dimensions or the part #? Jim

Do you happen to have any pictures you could email? Also can you measure thr rotor thickness. thanks Jim

try here http://forums.corvetteforum.com/zerothread?id=653712 jim

I believe those springs will lower the nose approx 1/4"

I bought some small plastic containers at a marine supply store, usually used to mix fiberglas resin. Once its poured out for use POR-15 says to seal the can immediately & not to return the unused material to the can. Make sure the lip of the can is clean & use some saran wrap otherwise you...

I bought 2 qts of POR-15 & 1 qt of Chassis coat & still have material left. Sor far I did the frame, cross members, front suspension, frame brackets, trailing arms, a bunch of bolts and some small parts. It really goes a long way. If I were to do it again I would buy 2 pint cans & then a few...

THAT"S WATY TO MUCH!!! Stuff is expensive!!! I used 1 qt POR-15 to do two coats on the frame & most of the suspension, brackets & cross members. Still working on the first qt of Chassis coat. Buy the pint cans of POR-15, its easier to close up & yields less waste. Follow their instructions, but...

I'll race ya to the finish :L Actually I haven't had time to work on the car in about a month. Had to finish up some work on the house. I used POR-15 on the frame as well. Make sure you wear some latex gloves or something similar. That stuff will not come off you skin very easily. Found V&PM...

Can you email me the pictures also. If Dave doesn't take them I'm interested. Thanks Jim jclifford@aaany.com

Dave I'm in no rush - still working on the rear suspension. I'm in the middle of a body off rebuild of a 70 454/390 vert. Still a couple of years away from being done. So far the frame is done as well as the front suspension. Rear trailing arms are done & I'm working on the differential, 1/2...

Dave Just checked a map - didn't realize Orange Park was so far from Orlando. Probably won't have time to get up that way. I'll be at a Hotel near Sea World. Any idea on shipping costs? Jim

I may be interested, which part #? Hedman has a few listed. Thanks Jim P.S. I'll be in Orlando next week on business. Might even be able to pick the up.

I was missing one.......ducts that is ;LOL Had to locate a used one. I ended up with an extra drivers side that you can have, just pay the shipping. It isn't perfect, a little out of shape but should be usable. Jim