Search results

As the title indicates, I lost 1st and 2nd gear on the way to work this AM. Every thing else seems to work fine. Any ideas.;help

I'm in the middle of the clutch job. Time to install roller pilot bearing. Which way does it go???Bearings toward engine or bearings toward tranny. Thanks:confused

My right rear wheel bearing is shot . Should I use the AC Delco replacement ($304.00) or are there aftermarket ones of similar quality?:confused Also when you have faced this do you just replace the bad one? in pairs ? or what

Clutch Fluid Leak, Transmission Slip, What Clutch?? My '86 with a 4+3 Trans. has developed multiple problems. First, I have hydraulic fluid leaking inside the car down the clutch pedal onto the pad. Second, all of a sudden now when I accelerate the engine revs up first for a few seconds then...

Ok, I popped the fused link that goes from the battery to the cooling fan relay. Can you get replacements still and if not what can I do. This link is molded into my + battery terminal connector, so I don't see how you could just "replace it". And while I'm at it , why would this burn anyway...

Went to fire up my 86 coupe this morning and you guessed it, Nada. Fuel pump comes on, pressure is good , no fire at plugs, Cranks at good pace for a few seconds then drags and my dash goes crazy (WTF)? New battery no help. No codes being displayed. Coil checks good, Distributor module? ECM...

Recently installed TPIS Big Mouth Intake manifold base plate. I replaced all the sensors with new ones. To make a long story short, now my coolant temp gauge always reads "Lo". I have checked everything else and system is working great. I also installed a 170 degree thermostat and 190 degree fan...

New Member, First Vette. I got the TPIS "Big Mouth" intake manifold, which came with the FelPro1205 gaskets,however the FelPros don't have the restrictor plates in place on the gaskets. I was told by a GM mechanic that not having these could cause an overheating situation on longer drives. I...