1969 door lock replacment - 1st post

[Red73BB]

Hello,

[TABLE="align: left"]
[TR]
[TD="align: left"]I’m replacing the door locks on my ’69 and would appreciate advice on the installation.[/TD]
[/TR]
[/TABLE]

I have replaced one and taking the lock out was not too bad, but putting in the new lock due to the tight area and new lock spring is difficult and took me hours. Am I missing an easier way to install?

Thanks,
Gary

 

[Red73BB]

...or is there a tool that can be purchased?

 

[6880 Mike]

No special tools; no special tricks. It might be helpful to know the doors were bare when the locks/handles were installed at the factory. The assembly instruction manual (AIM) shows diagrams of the installation which can be helpful.

 

[GTR1999]

When I do mine, I remove the latch assembly completely from the door, clean and lube it. With that out I can get to the door lock cylinder,remove the clip and out it comes. You may want to run a razor blade along the outside of the lock bezel IF there is paint on it from a post factory paint job. Just a precaution so you don't chip the paint.

Happy Thanksgiving!