G
Gunrunner
Guest
I had to replace the ignition cylinder on my 1979 Corvette. I got the whole thing out and was starting to put it back together and a piece popped out. I finally figured out it was part of the turn signal cancel but now i can't figure out how it goes back in. It's a plastic piece with a little curve on it that seems to fit right into where the turn signal arm is. But i'm not sure if there was another part that popped out becuase i cant seen to get it to go back on right. I know this is kind of vaugue but its all i have right now because the piece popped out when my hand had it covered so i couldn't see where it came from. Anyone ever had to do this before and might have some insight? Thank You.
