327/300 ignition question

[PG-LT4]

Dummy me, I took pictures of the for the coil/distributor wire set up before I disassembled but before I could download them one of my kids used the camera…need I go on?
Anyway, does any one have pictures of the wire orientation they can send to me? I’m ok with the plug wires I just need help with the other ones! It’s been 30 + years since I’ve done one of these and the old gray matter is a little rusty! (too many beers so little time!)
Specs are 327/300 1966 roadster with a single wire electronic ignition. At least I think that’s what you call it…no points! No other mods!
My e-mail is mikeuuv@columbusmail.com
Thanks
Mike

 

[JohnZ]

The single wire from the "Breakerless SE" module in the distributor goes to the (-) coil terminal; the (+) coil terminal gets a pink wire from the ignition ballast resistor and another pink wire from the "R" terminal on the starter solenoid.