C2 inner fender well to top surround panel junction

[garywilkerson]

I'll be working on my 66 front end this summer, I've noticed several c2's at shows recently where the inner fender well to top surround panel juncture varied from almost touching (with just a bit of adhesive) to a junction that is up to 3/4+" high (noticeable flat area facing into the engine bay). In all cases the hood and surround panel fit well.
What causes the differences in the height of this joint and whats typical from the factory?

Thanks in advance.
Gary

 

[RestoCreations]

I'll be working on my 66 front end this summer, I've noticed several c2's at shows recently where the inner fender well to top surround panel juncture varied from almost touching (with just a bit of adhesive) to a junction that is up to 3/4+" high (noticeable flat area facing into the engine bay). In all cases the hood and surround panel fit well.
What causes the differences in the height of this joint and whats typical from the factory?

Thanks in advance.
Gary

Variations in fiberglass. The joints on the skirts will vary a lot and are adjusted with more or less adhesive to make the fenders level with the hood. There really isn't a set standard, just whatever makes the hood fit your fenders the best.