Exhaust manifolds - trouble getting everything back together

[Stallion]

I'm having the classical problem of not being able to get everything back together. The engine is out and I had her rebuilt. Now it's time to piece everything back together and there are a few parts that I can't recall where they go.

There are manifold pieces/shields/bolts. Any help with piecing these few parts back together will be MUCH appreciated.

 

[JohnZ]

The two items on the left are to route the plug wires, and attach on the rear block flange behind the cylinder heads with 1/4"-20 bolts. The two sheet metal shields go on the exhaust manifolds - the hole in the lower one is for the temp sensor between #6 and #8 cylinders, and the upper one is a spark plug shield that attaches to the two brackets on the exhaust manifold above the #5 and #7 plug holes. The "boomerang"-shaped stamping contains the #1 and #3 plug wires on the left side, and there should be another one to contain the #2 and #4 plug wires on the right side; the end with the stamped hole attaches under the top rear motormount-to-block bolt, and the bent bracket with the slot in the end goes under the same bolt that attaches the rear spark plug heat shield on each side.