Headlight motor switch

[SIXt7]

The small round connector at the end of the green wire to the pin on the switch broke off. Any suggestions on fabricating a new connector to the switch pin? Switch and motors work fine when I touch the raw green wire to the pin on the switch.

 

[Gerry]

The small round connector at the end of the green wire to the pin on the switch broke off. Any suggestions on fabricating a new connector to the switch pin? Switch and motors work fine when I touch the raw green wire to the pin on the switch.

Solder a pair of spade connecters to each end.
Gerry

 

[67l36driver]

You can purchase a new connector w/pigtail from one of the vendors, or do like I did and beg one from a fellow forum member who has replaced his dash harness.

Thanks to Larry Cross on the 'other' forum.

 

[SIXt7]

Thanks for all the suggestions. I crimped a spade connector to the wire end and formed it to fit on the switch post. Fits tighter than the other two and works very well.