cals1993
Member
Just purchased a 1993 vette it has that huge greenwood wing . Does anyone know how to remove it do I go from the inside of the trunk or from tail lights? or else were ?
How to remove greenwood spoiler?
- Thread starter cals1993
- Start date
pologreen1
Active member
can I see some pics of it? I might like to buy it for my car. thanks
- Thread starter
- #3
cals1993
Member
You can see it in my profile pic or I can e-mail it to you, it would look good on your car you have the ground effects that go with it it doesn't look right with out it. Renato
pologreen1
Active member
nope I see nothing in your avitar or anything. are you on anyother forums to see it? is it for the 91's and later I take it?
- Thread starter
- #5
cals1993
Member
It,s off a 1993 aqua c4 mint condition. I just need to figure out how to get it off. If you lived local I would have told you to come by and take it for free if you could get it off. This is my e-mail cals69z28@yahoo.com, send me a message and I WILL E-MAIL YOU BACK THE PICS.
K
kenmack
Guest
Don't know how !!!!
take off license and probably all 4 tailights.
Should give you access.
BUT
At all costs take that abomination offffffff
otflotflotfl
take off license and probably all 4 tailights.
Should give you access.
BUT
At all costs take that abomination offffffff
otflotflotfl
While you may want it off now, doesn't the greenwood spoiler require some very sizeable holes in the rear deck area so that it can be mounted? I could be remembering wrong, but it's something to check into to make sure you know what kind of holes you're going to have to do something with once you have it off if you hadn't already considered that.
tcxd40
Well-known member
- Joined
- Mar 7, 2007
- Messages
- 387
- Location
- Pittsburgh
- Corvette
- (2) Black '93s, purple '81, '69 vintage racer
Removal of the reverse lights and plate will make it easier to remove the tail light assemblies. You should beable to access the studs from once all is removed.
Yes it will leave holes in the rear fasica panel and they can't be filled where as you would not notice the repair. The best way is to repalce the panel but that is expensive. Filling the holes with some type of decorative plug may work but you will always be able to tell that a wing was on it .
tcxd40
Yes it will leave holes in the rear fasica panel and they can't be filled where as you would not notice the repair. The best way is to repalce the panel but that is expensive. Filling the holes with some type of decorative plug may work but you will always be able to tell that a wing was on it .
tcxd40
Similar threads
Corvette Forums
Supporting Vendors
Dealers:
