Mounting Painless wiring harness

[henny496]

Hello
I have an 18 circuit Painless harness to put in the car( just had an overhead panel on the cage before) and I am trying to install it neatly
I was hoping to put it behind the glove compt, but it basically is going to be level with the glove compt door in order to fit(wiper arms in the way)
If anyone has installed one, where was the best spot you found to fasten it?
take care
Tom

 

[BADBIRDCAGE]

Tom: I put mine in the original location on the firewall. It fits fine there.

Rich

 

[henny496]

Hello Rich
Thanks for your reply. My floor has been altered somewhat and the car is quite custom. I did try to retain the stock shape throughout the car
Do you have a pic of where it is in your car?
thanks
Tom

 

[BADBIRDCAGE]

Tom: I'll get out to the garage and take a picture tomorrow. Then I can e mail it to you.

Rich

 

[henny496]

Rich
I would appreciate that if it is not too much trouble for you. I am worried about putting it where it may interfere with the dash or whatever else
henny496@hotmail.com
thanks very much for your time
Tom

 

[BADBIRDCAGE]

Tom: Sent you an e mail with pics. Hope it helps.

Rich

 

[henny496]

Hi Rich
I just saw the pics and yes that does help me considerably. I don't have the fiberglass area(as stock) where the fuse block was and I was concerned about intefering with something that I have yet to bolt on
I almost was going to bolt this in the glove compt, but I am really glad I asked here first.
thanks very much for your help
Tom