Welcome to the Corvette Forums at the Corvette Action Center!

Parking brake is stuck on!

Edmond

Well-known member
Joined
Aug 1, 2001
Messages
5,218
Location
Louisiana
Corvette
2003 Z06
I was working on the car today and had the parking brake on. When I took the car off the ramps; I disengaged the parking brake and the handle went down without any resistance whatsoever.

I drove about 20 feet to see if my suspicions were true. I let the car idle when driving and sure enough, it stopped itself.

The brake light didn't come on because I took the bulb out a couple years ago due to a parking brake issue.

Can I just disable it? I don't think I'm going to replace it because I really don't have a need for it.
 
P-brake

did you try pulling the handle all the way up until it re-engages them push the button to release?
 
samborskij said:
did you try pulling the handle all the way up until it re-engages them push the button to release?

Yes, I did try that but no luck. :eyerole
 
Edmond said:
The brake light didn't come on because I took the bulb out a couple years ago due to a parking brake issue.
A parking brake issue? Sounds like this was something just waiting to happen. :eyerole

The parking brake is a drum brake setup inside the disc rotor on the eary C4s and it's probably just corrosion and dirt. You can try to free up the brake linings by adjusting them with an old-fashioned brake spoon (or screwdriver), but most likely you'll have to remove the wheels and clean the entire assembly. It isn't that hard to do really. ;)
 
Ken said:
The parking brake is a drum brake setup inside the disc rotor on the eary C4s and it's probably just corrosion and dirt. You can try to free up the brake linings by adjusting them with an old-fashioned brake spoon (or screwdriver), but most likely you'll have to remove the wheels and clean the entire assembly. It isn't that hard to do really. ;)


I was afraid that you'd say that. I tried to engage the thumb button again and engage the brake to turn the parking brake off but no luck.

Good news is that my mechanic neighbor should be coming over this afternoon and give me some pointers.

Is it really necessary for me to have a functional parking brake?
 
Edmond said:
Is it really necessary for me to have a functional parking brake?
Does Illinois require an annual safety inspection?

Otherwise you may just need it in situations similar to when it broke. To keep it from rolling over you.;help
 
Just off center between the rear wheels you will see a cable. You can unadjust that cable then move the car in reverse to disengage the break linings. You may get lucky.
 
The C4 parking brake had an inherent problem with the application of the brake. If you pull up on the handle too far when setting the brake, the cable can come off the pulley or seperate causing you to be unable to release the brake. The secret is when setting the brake to not pull the handle up that last 1/2inch of travel. I had uneducated mechanics break mine twice by trying to pull the handle out of the car. A firm set is all that is required. Having an operational parking brake is always a good idea.
Good luck, Paul
 
JRMaroon said:
Does Illinois require an annual safety inspection?

Otherwise you may just need it in situations similar to when it broke. To keep it from rolling over you.;help

I don't think we have an annual safety inspection. At least not that I know of. :)

That's how I broke it; to keep the car from rolling over me! Oh the irony. :L I was working on the exhaust and rear sway bar bushings. I jacked the rear end up to put the car on my Rhino Ramps. I put the brake on so it wouldn't roll off. When I tried to push the lever back down, it went straight down and the parking brake didn't disengage. :(
 
Paul T said:
The C4 parking brake had an inherent problem with the application of the brake. If you pull up on the handle too far when setting the brake, the cable can come off the pulley or seperate causing you to be unable to release the brake. The secret is when setting the brake to not pull the handle up that last 1/2inch of travel. I had uneducated mechanics break mine twice by trying to pull the handle out of the car. A firm set is all that is required. Having an operational parking brake is always a good idea.
Good luck, Paul

Paul,

Unfortunately, that's what I did. I guess I'm not used to it because on my Toyota, they use the pedal type, not the lever type.

JonM,

I'm going to try and get lucky! ;)
 
Edmond said:
Is it really necessary for me to have a functional parking brake?
State inspection requirements or no, you really should have a parking brake on your vehicles. It just makes (safety) sense. ;)
 
Problem solved!

So my neighbor came over and took care of the problem for me. I showed him the problem and went back inside to get the keys. By the time I came back out; he had it fixed.

He just pulled the lever a little higher until it engaged and that was it! :D I think I'm gonna go for a nice cruise tonight. :w
 
Edmond said:
So my neighbor came over and took care of the problem for me. I showed him the problem and went back inside to get the keys. By the time I came back out; he had it fixed.

He just pulled the lever a little higher until it engaged and that was it! :D I think I'm gonna go for a nice cruise tonight. :w
Outstanding. That is the way all problems should turn out. Enjoy the cruise.
Paul
 

Corvette Forums

Not a member of the Corvette Action Center?  Join now!  It's free!

Help support the Corvette Action Center!

Supporting Vendors

Dealers:

MacMulkin Chevrolet - The Second Largest Corvette Dealer in the Country!

Advertise with the Corvette Action Center!

Double Your Chances!

Our Partners

Back
Top Bottom