Question: Reassembling my interior.

[lheindrich]

So I have made alot of headway on the interior for my 75. I have the rear compartment together and I have retrofitted a set of shoulder strap seatbelts off of a Camaro I have also lined the whole interior with reflectix and completely refinished the seats right down to the frames not to mention a bunch of other stuff. I am at the point where I am ready to put the whole dash back together but I am not sure where to begin anyone out there done this before?

 

[TimAT]

I've had my 69 and 77 apart and back together. My thinking is work from the left side to the right. I've done both that way and it seems easier since you can keep a watch on the dash harness as you assemble.

 

[White75]

So I have made alot of headway on the interior for my 75. I have the rear compartment together and I have retrofitted a set of shoulder strap seatbelts off of a Camaro I have also lined the whole interior with reflectix and completely refinished the seats right down to the frames not to mention a bunch of other stuff. I am at the point where I am ready to put the whole dash back together but I am not sure where to begin anyone out there done this before?

Here's a link to my renovation thread:
http://www.corvetteactioncenter.com...111866-interior-replacement-our-75-coupe.html

In short, you'll want to do the upper dash, then the 2 lower sections, then the center console. If you pulled the A-pillar trim and header bar, you'll have to put in the A-pillar trim in after the dash (it will make it a lot easier to fit the dash in without damage, if it's not impossible to put in the first place) and then the header bar. Check my thread for more detailed info and post up any other questions you may have.
Good luck!